Loading ...
Loading ...
Loading ...
6
Operation
IR Remote Control
The following section describes how to operate the remote. “N” indicates a number value (1–8).
“+” indicates continuous pressing. There is no “+” button.
1) The format of switching channels (inputs to outputs) with the remote control is as follows:
Input (N) + Switch + Output (N), Input (N) + Switch + Output (N), …. + Enter.
For example: If you wish to send Input 1 to Output 2 and Input 2 to Output 4,
the sequence will be: Input (1) + Switch + Output (2) + Input (2) + Switch
+ Output (4) + Enter.
2) To select multiple outputs for one input, an example would be:
Input (1) + Switch + Output (2) + Output (5) + Output (8) + Enter.
3) “ALL” is the shortcut button to select all output channels (displays).
It works in the following fashion: ALL + Input (N) + Enter.
TCP/IP GUI Control
The GUI Control software is available on the included CD and at tripplite.com. GUI software is not compatible with macOS
®
.
1) Run the dedicated GUI software on the target computer to be used.
2) Set the correct COM port number and the following communication parameters: 9600 bps, 1 start bit, 1 end bit, no
check bit. Set the data format as ASCII and open the serial port.
3) The Matrix Control System has four different tabs. Each one will be explained in the following steps.
Loading ...
Loading ...
Loading ...