Loading ...
Loading ...
Loading ...
Delaystart
Youcandelaythestartof the programin 1-hourstepsup to 24 hours.
, Openthe door (forhiddencontrolsonly).Turnuniton usingtheON/OFFbutton.
, Press"+" buttonuntilthetimer programmingdisplayjumpsto 01 .
, Press + or- button until the displayed time corresponds with your requirements.
, Press START button. Delay start is activated.
To cancel delay start:
, Press the + or- button until "00" is indicated on the digital display.
You can change your program selection at any time until the program starts.
, Close the door (for hidden controls only).
Cycle Completion Signal
The cycle completion is also indicated by a tone.This function can be changed as
follows:
, Open the door (for hidden controls only). Turn unit on using the ON/OFF button.
, Hold down "A" button and press START button until the display shows H:00.
, Release both buttons.
, Press "A" until the display shows "b:02".
, Press "C" to increase or decrease the tone.
• b:00 = Off and b:03 = loudest
, Press START to save the setting.
Intensive drying
The final rinse uses a higher temperature which improves the drying result.
The running time may increase slightly. (Caution if utensils are delicate!)
, Open the door. (for hidden controls only). Turn unit on using the ON/OFF button.
Hold down "A" button and press START the digital display shows "H:00".
, Release both buttons.
, Press button "A" until the display indicates "d:00"
To change the setting,
, Press button "C" (see page 4) to turn intensive drying ON = d:01 or OFF = d:00
, Press START button. The set value is saved.
, Close the door (for hidden controls only).
Switching on the appliance
, For hidden controls, open the door.
, Turn unit on by pressing the ON/OFF switch. The display of the last
selected program flashes.
, The expected program duration flashes on the digital display.
, Press the START button.
, Close the door. The program starts running.
Interrupting the cycle
, Open the door (for hidden controls only).
, Press the ON/OFF button. The LEDs go out. The program is saved. If the door
was opened on an appliance which has a warm water connection or is heated,
first leave the door ajar for several minutes and then close. Otherwise, expansion
(pressure) may cause the appliance door to spring open or water to run out of
the appliance.
, To continue the program, switch on the ON/OFF switch again.
, Close the door.
15
Loading ...
Loading ...
Loading ...