Loading ...
Loading ...
Loading ...
Mount the baby unit on dry wall (optional)
Place the wall mount bracket on a wall
and then use a pencil to mark two holes in
parallel.
Note
• Check for reception strength and camera
angle before drilling the holes.
Drill two holes in the wall ( 7/23 inch drill bit ).
If you drill the holes into a stud, go to step 3.
-OR-
If you drill the holes into an object other than
a stud, insert the wall anchors into the holes.
Tap gently on the ends with a hammer until
the wall anchors are flush with the wall.
Align the wall mount bracket and
screws with the holes in the wall as
shown. Tighten the screw in the middle
hole first, so that the wall mount bracket
position is fixed. You can tighten the
other screw in the top hole.
Place the camera unit on the wall mount
bracket, and then slide it forward until
it locks into place. Connect the power
adapter to the camera unit and a power
supply not controlled by a wall switch.
Notes
• Check for reception strength and camera
angle before drilling the holes.
• The types of screws and anchors you
need depend on the composition of
the wall. You may need to purchase the
screws and anchors separately to mount
your camera units.
Loading ...
Loading ...
Loading ...