Loading ...
Loading ...
Loading ...
"VARI-SPEED" DRIVECONTROL
• Self-propellingiscontrolledbyhold-
ingthe operatorpresencecontrolbar
downto thehandleand pullingthedrive
controlbarup tothe handle. Thecloser
tothe handlethe barispulled,thefaster
theunitwilltravel.
• Forwardmotionwillstopwheneither the
operator presence control bar or drive
control bar are released. To stop forward
motion without stopping engine, release
the drive control bar only. Hold operator
presence control bar down against
handle to continue mowing without self-
propelling.
NOTE: If after releasing the drive control the
mower will not roll backwards, push the mower
forward slightly to disengage drive wheels.
FRONT WHEEL DRIVE MODELS ONLY:
• To keep drive control engaged when
turning corners, push down on the
handle to lift the front wheels off the
ground while turning lawn mower.
O erator presence control bar
DRIVE
CONTROL
ENGAGED
control bar
DRIVE
CONTROL
DISENGAGED
VARI-SPEED "THUMBSCREW"
ADJUSTMENT
Over time, the drive control system may
become "loose", resulting in decreased
speed. There is a thumbscrew on the
underside of the drive control housing to
increase tension on the drive cable. Pro-
ceed as follows:
• Turn unit off and disconnect spark plug
wire from spark plug.
• Rotate thumbscrew counter-clockwise to
tighten the drive cable.
• Operate mower to test drive speed.
• If condition fails to improve after the
above steps (forward speed remains
the same), your drive belt is worn and
should be replaced.
NOTE: If mower begins to "creep" forward,
the drive cable is too tight. Rotate thumb-
screw clockwise to loosen drive cable.
VARI-SPEED "BLOCK" ADJUSTMENT
Over time, the drive control system may
become "loose", resulting in decreased
speed. There are holes in the drive control
housing to increase tension on the drive
cable. Proceed as follows:
1. Turn unit off and disconnect spark plug
wire from spark plug.
2. Loosen nut, move drive control hous-
ing down handle to the next hole and
retighten nut.
3. Operate mower to test drive speed.
4. If condition fails to improve after the
above steps (forward speed remains
the same), your drive belt is worn and
should be replaced.
TO ADJUST, MOVE DOWN TO NEXT HOLE
13
Loading ...
Loading ...
Loading ...