Loading ...
Loading ...
Loading ...
4
Using Your Snow Cone Maker:
1. Place the Snow Cone Maker on a stable, waterproof surface.
2. Remove the Snow Cone Holder from the base of the unit and reattach the Snow Cone
Holder so that it faces upward.
3. Before plugging in the unit, add ice cubes to the Ice Hopper by removing the Lid. In order
to do so, turn the Lid clockwise, lift and remove.
4. Plug the unit into an electrical outlet. Place a cone in the Snow Cone Holder.
5. When you are ready to make a snow cone, place the Lid back on the unit and turn Lid
counter-clockwise to lock.
6. The Ice Hopper will immediately begin shaving the ice. Rotate cone with your hand as
needed to collect ice.
7. To stop the Ice Hopper from shaving ice, turn the Lid clockwise.
8. Repeat the process until you have shaved the amount of ice desired.
Tips:
• Ice cubes should sit a short while before putting them in the shaving unit. If ice has a frosty
• appearance, it is too hard to shave. Let ice sit until it is translucent and wet to the touch.
Then it is ready to put in the Ice Hopper.
• While ice is shaving, it will empty from Spout and may get on surface and floor around the
Snow Cone Maker. This is normal. In order to prevent messes:
− Place unit on a waterproof surface while in use.
− Rotate cone in holder as needed in order to fill cone evenly.
− After you are finished making snow cones, make sure Ice Hopper is empty so that ice
does not melt onto surface.
• If the unit begins to shake, make sure that the suction cups on the bottom of the unit are
firmly pressed into table or countertop.
Cleaning Your Blender:
WARNING: Always unplug the product and allow it to cool before cleaning or storing it.
• Only the Cones and Lid can be washed under running water. Do not use abrasive cleaners.
• Handle blades with extreme caution.
• The Body may be wiped with a soft damp cloth.
NOTE: NEVER IMMERSE THE BASE
• Dry all parts thoroughly before storing in a cool, dry place, away from reach of children.
Loading ...
Loading ...
Loading ...