15-ft Steel Hammock Stand
End Pole
(D)
End Pole
(D)
Base Pole
(C)
Holes for “Z” Hooks
(E)
(A)
(A)
Base Bracket
(B)
Base Bracket
(B)
WARRANTY
CAUTION
If you are not familiar with hardware, please use a
qualified general contractor to install. Improper installation
may cause injury.
Safety First: Before using the hammock stand, inspect all
parts and hardware as well as installation points and objects
supporting your hammock for wear or weakness. Be sure all
parts are properly secure, including the hardware. The
Z-hooks, Hex Nuts, & Washers should all be tight and secure.
Make sure there is no excessive rust or twisting in the any of
the hardware and parts. The hammock stand is not a
playground or toy. Rough play may result in falls and may wear
out your hammock stand and hardware prematurely. Small
children should not play unsupervised in your hammock stand.
Carefully, follow the directions of your hammock stand &
hammock (sold separately).
Double check to make sure you have all
parts and hardware listed. If you are missing
parts or hardware, feel free to contact us at:
Hardware Included:
A. (2) Round Rubber End Caps*
*Caps may already be attached
to the end of the poles
B. (2) Base Brackets
C. (1) Base Pole
D. (2) End Poles
E. (2) “Z” Hooks
Assembly: No tools required
If Round Rubber End Caps (A) are not
already on the ends of the poles, place
Round Rubber End Caps (A) on End
Poles (D) near the “Z” Hook (E).
Place the (2) Base Brackets (B) on the
floor, and connect the Base Pole (C) to the
(2) Base Brackets (B).
Insert the (2) End Poles (D) into the other
ends of the Base Brackets (B). Make sure
that you insert the side of the End Poles (D)
without the holes.
Place the (2) “Z” Hooks (E) into the holes,
which will be used to hang the hammock.
1.
2.
3.
4.
For 10-ft to 14-ft Hammocks
Depending on the overall length of your hammock, you may
need extra chains & “S” hooks (sold separately).
®
BY SUNJOE
Made in China
Max Weight Capacity: 500 LBS (226.8 KGS)
©Bliss Hammocks is a Registered Trademark of Snow Joe, LLC
