Frigidaire FFRS08C3Q10 Official Room Air Conditioner

User Manual - Page 11

For FFRS08C3Q10.

PDF File Manual, 12 pages, Download pdf file

Loading ...
Loading ...
Loading ...
Beforecallingforservice,reviewthislist,Itmaysaveyoutimeandexpense,Thislistincludescommonoccurrencesthatarenot
theresultofdefectiveworkmanshipormaterialsinthisappliance
OCCURRENCE SOLUTION
Air conditioner will not operate.
Air _om unitdoes not feelcold
enough.
Walt plug disconnected. Push plug firmly into walt outlet.
Plug Current Device Tripped. Press the RESET button.
House fuse blown or circuit breaker tripped. Replace fuse with time delay type or reset circuit breaker.
Control is OFF. Turn Control ON and set to desired set:Ling.
Room temperature below :[6 °C (60 °F). Cooling may not occur until room temperature rises above
:[6°C (60 °F).
Temperature sensing element touching co_d coil, located behind air filten Straighten away from coil.
Reset to a lower temperature.
Compressor shut-off by changing modes. Wait approximately 3 minutes and listen for compressor to
restart when set in the COOL mode.
Air conditioner cooling_ but room
is too warm -ice forming
on cooling coil behind decorative
front
Outdoor temperature below :[6 °C (60 °F). To defrost the coil, set FAN ONLY mode.
Air filter may be dirty. Clean filtec Refer to Care and Cleaning section. To defrost, set to FAN ONLY
mode.
Temperature is set too low for night-time cooling. To defrost the coil, set to FAN ONLY mode. Then,
set temperature to a higher set:Ling.
Air conditioner cooling_ but room
is too warm -NO ice forming on
cooling coil behind decorative
front.
Dirty air filter - air restricted. Clean air fiiten Refer to Care and Cleaning section.
Temperature is set too high. Set temperature to a lower set:Ling.
Air directional louvers positioned improperly. Position louvers for better air distribution.
Front of unit is blocked by drapes, blinds, furniture, etc. - restricts air distribution, aear blockage in
front of unit.
Doors, windows, registers, etc. open - cool air escapes. Close doors, windows, registers, etc.
Unit recently turned on in hot room. Allow additional time to remove "stored heat" from walls, ceiling,
floor and furniture.
Air conditioner turns on and off
rapidly. Dirty air filter - air restricted. Clean air filten
Outside temperature extremely hot. Set FANspeed to a faster setting to bring air through cooling coils
more frequently.
Noise when unit is cooling. Air movement sound. This is normal. If too loud, set to lower FAN selling.
Window vibration - poor installation. Refer to installation instructions or check with installer.
Water dripping INSIDE when Improper installation. Tilt air conditioner slightly to the outside to allow water drainage. Refer to
unit is cooling, installation instructions or check with installer.
Water dripping OUTSIDE when Unit removing large quantity of moisture from humid room. This isnormal during excessively humid
unit is cooling, days.
Room tOO cold. Set temperature too low. Increase set temperature.
If These Solutions Fail, Call :[-800-265-8352 For Frigidaire Service.
©2009 Electrolux Home Products, Inc. All rights reserved. 1 1
Loading ...