Loading ...
Loading ...
Loading ...
4
2. CONTROLS
All units are equipped with an
integrated control, located under
the unit, in front of the electrical
compartment. Use the push button (1)
to control the unit. The LED (2) will
then shows on which mode the unit is
in. Refer to table below.
WARNING
Risk of electric shock. Before performing
any maintenance or servicing, always
disconnect the unit from its power source.
AVERTISSEMENT
Danger d’électrocution. Débranchez
toujours l’appareil avant d’entreprendre
des travaux d’entretien ou de réparation.
CAUTION
Unscrew both screws to open the electrical
compartment. To completely remove, detach
from its retention wire inside.
ATTENTION
Dévisser les deux vis pour ouvrir le compartiment
électrique. Pour retirer complètement, le
détacher de son fil de rétention intérieur.
No li g ht OFF or remote controled
Amber light LOW speed
Green ligh HIGH speed
Blinking light See User Manual
Sans lumière Arrêté ou contrôlé
par contrôle mural
Lumière ambre Basse vitesse
Lumière verte Haute vitesse
Clignotant Voir guide d’utilisation
VD0182
12
LED COLOR RESULTS
AMBER UNIT IS ON LOW SPEED
GREEN UNIT IS ON HIGH SPEED
NO LIGHT UNIT IS OFF OR CONTROLLED BY A MAIN CONTROL
If a problem occurs during the unit operation, its integrated control LED (2) will blink.
The color of the blinking light depends on the type of error detected. Refer to Section 4
TROUBLESHOOTING on last page for further details.
NOTE: When using an optional main wall control, the integrated control must
be turned off.
2.1 INTEGRATED CONTROL
Loading ...
Loading ...
Loading ...