Loading ...
Loading ...
Loading ...
Odfic8
Holder
Figure 1
Cleaning the Burner Grates, Burner Caps and Burner Heads
The Burner Grates, Burner Caps and Burner Heads should be routinely cleaned.
Keeping the burner ports clean will prevent improper ignition and an uneven flame
at each burner position. Refer to the following instructions.
To Remove and Replace the Surface Burner Grate, Surface Burner Cap and
Surface Burner Head - Remove in the following order; (1st) Center Burner
Grate, (2nd) Surface Burner Grate, (3rd) Surface Burner Cap, (4th) Surface Burner
Head (See Figure 1).
Reverse the procedure above to replace the Surface Burner Cap, Surface Burner
Head and Surface Burner Grate. Do not remove any burner parts from the
cooktop until the burner parts have completely cooled and are safe to
handle. Do not operate the surface burners without the Surface Burner Caps,
Surface Burner Heads and Surface Burner Grates properly in place.
To Clean the Burner Caps, Burner Heads and Burner Grates - Use a soap-
filled scouring pad or a mild abrasive cleanser to clean the surface burner caps
and surface burner heads. The ports (or slots) around the burner heads must be
routinely cleaned. If residue still remains in these ports, use a small-gauge wire or
needle to clean the slots or holes. For proper flow of gas and ignition of the
burner--DO NOT ALLOW SPILLS, FOOD, CLEANING AGENTS OR ANY
OTHER MATERIAL TO ENTER THE GAS ORIFICE HOLDER OPENING.
ALWAYS keep the surface burner cap and surface burner head in place whenever
a surface burner is in use.
Care and Cleaning of Stainless Steel (Stainless Steel models only)
Some models are equipped with stainless steel exterior parts. Special care and cleaning
are required for maintaining the appearance of stainless parts. Please refer to the table
provided at the beginning of the General Care & Cleaning section in this Use & Care
Manual.
Removing and Replacing the Oven Door
The door is heavy. For safe, temporary storage, lay the door flat with the
inside of the door facing down.
To Remove Oven Door:
1. Open the door.
2. Remove screws located on the inside of the oven door near the hinges A (one on
each side.)
3. Close the door to the quarter-open position. Grasp the door firmly on both sides and
lift up and off the hinges.
4. To clean oven door, follow the instructions provided in the General Care & Cleaning
table on page 29.
To Replace Oven Door:
1. Be sure the hinge arms are in the quarter-open position. Be careful if pulling the
hinges open by hand. The hinges may snap back against the oven frame and could
pinch fingers.
2. Hold the door at the sides near the top. Insert the hinge arms intoslots at the bottom
of the door.
3. Hinge arms must go into the range slots evenly. The hinge arms should be inserted
into the bottom corners of the door as far as they can go.
4. Ifthe door is not in line with the oven frame, remove it and repeat the above steps.
30
Loading ...
Loading ...
Loading ...