Loading ...
Loading ...
Loading ...
32
English
MODIFICATIONS
Hitachi Power Tools are constantly being improved
and modifi ed to incorporate the latest technological
advancements.
Accordingly, some parts may be changed without
prior notice.
Important notice on the batteries for the Hitachi
cordless power tools
Please always use one of our designated genuine
batteries. We cannot guarantee the safety and
performance of our cordless power tool when used
with batteries other than these designated by us, or
when the battery is disassembled and modifi ed (such
as disassembly and replacement of cells or other
internal parts).
SERVICE AND REPAIRS
WARNING
●
Only service personnel trained by Hitachi,
distributor or employer shall repair the Nailer.
●
Use only parts supplied or recommended by
Hitachi for repair.
All quality Nailers will eventually require servicing or
replacement of parts because of wear from normal use.
NOTE
Specifi cations are subject to change without any
obligation on the part of HITACHI.
Maintenance chart
ACTION WHY HOW
Clean magazine and feeder
mechanism.
Prevent a jam. Blow clean daily.
Keep push lever working properly. Promote operator safety and effi cient
Nailer operation.
Blow clean daily.
Operator troubleshooting
Most minor problems can be resolved quickly and easily using the table below.
If problems persist, contact a Hitachi authorized service center for assistance.
PROBLEM CHECK METHOD CORRECTION
Power switch doesn’t turn on.
Turn on once, but turn off
automatically.
Low battery charge. Charge the battery.
Damaged internal electronics. Contact Hitachi for replacement.
Push lever and/or trigger is ON state ? Keep push lever and trigger in OFF
state.
Keep no operation over 30 minutes ?
(Auto-power off function)
Push and hold power switch more
than 1 second to switch “ON”
Nailer doesn’t operate
(Power switch ON).
Nailer not enough pressed against
workpiece.
Hold nailer fi rmly and press to the
workpiece completely.
Trigger not enough pulled. Pull the trigger fi rmly.
More than 2 seconds pass from push
lever ON to trigger ON (or trigger ON
to push lever ON).
Make sure that less than 2 seconds
pass between push lever ON and
trigger ON (or between trigger ON
and push lever ON).
Preventive mechanism activated.
(No nails, or too few fasteners
remaining)
Reload the nails into magazine.
Lock lever(Trigger lock function) is
“ON” position.
Set Lock lever to “OFF” position.
(Refer to page 23 – 24)
Machine is too cold (below 23°F
(-5°C)) or too hot.
Allow the nailer to cool or warm-up
throughly in adequate condition.
Damaged internal electronics. Contact Hitachi for replacement.
000BookNR1890DC.indb32000BookNR1890DC.indb322017/06/2912:30:422017/06/2912:30:42
Loading ...
Loading ...
Loading ...