JET SLT-660F Manual

Loading ...

Assembly

Note: The SLT-660F does not require any

assembly.

1. On the SLT-1650, attach the handle (A, Figure

1) to the frame using two hex cap screws, two

lock washers, two flat washers. Tighten with a

19mm wrench.

Note: The two pivoting casters can be locked

so that they do not rotate. Press foot lever (B,

Figure 1 for SLT-1650) down to lock. Press

foot lever (A, Figure 2 for SLT-660F) down to

lock.

2. Attach foot lever (A, Figure 3) to the lever

bracket (B, Figure 3) with one hex cap bolt,

one flat washer, one lock washer (C, Figure 3).

Tighten with a 14mm wrench.

Keep hands and feet clear of

table and scissor lift openings while

lowering load. Failure to comply may cause

serious injury!

3. Pump the foot lever several cycles so that the

table is out of your way while attaching the

cable.

Note: Place a 2” x 4” board straight up and

down between the table and frame so that the

table cannot come down on you while

attaching the cable.

4. Route the cable (A, Figure 4) into the cable nut

(B, Figure 4). Run the cable through the

lowering mechanism (C, Figure 4) and pull the

cable tight. Tighten the hex nut (D, Figure 4)

using a 14mm wrench.

Note: You may have to turn the hex socket

cap screw to line up the hole. This will allow

the cable to pass through freely.

Figure 4

Figure 1

Figure 2

Figure 3

Loading ...

JET SLT-660F Scissor Lift Table with Folding Handle, 660 Lb. Capacity