OPERATING AND INSTALLATION INSTRUCTIONS
BUILT-IN VITROCERAMIC HOB
CONTENTS:
DESCRIPTION OF THE HOB 3
SAFETY INSTRUCTIONS 4
INSTALLATON 6
Locating Your Built-in Hob 6
Electrical Connection of Your Hob 8
USAGE 10
Residual Heat Functions 10
CLEANING AND CARE 11
......................................................
............................................................
.............................................................................
.........................................................
............................................
.........................................................................................
.............................................................
2
................................................................
3
DESCRIPTION OF THE HOB
OVAL ZONE
HEATER
VITROCERAMIC
SURFACE
KNOB CONTROL
PANEL
SINGLE ZONE
HEATER
Dear Customer,
It is important that you should read this manual for best performance and
to extend the life of your appliance. We recommend you to keep this manual
for future reference.
Your new hob is guaranteed and will give lasting service. This guarantee
is only applicable if the appliance has been installed and operated in
accordance with the operating and installation instructions detailed in this
manual.
Note: Appearance of your hob maybe different than the model shown above
due to its configuration.
HOB
FRAME
RESIDUAL
HEAT INDICATOR
4
SAFETY INSTRUCTIONS
Please comply with these instructions. If you do not, any damage
resulting from improper, incorrect or negligent use or improper
connection or installation is not covered by the warranty.
· This appliance should be used only for normal domestic use.
· This appliance must only be used for the purpose of heating or cooking
food, any other use, for example heating rooms, working surface or storage
surface, is dangerous.
· Additions or modifications to the appliance are not permitted.
· Do not place or store flammable liquids, highly inflammable materials or
fusible objects on or near the appliance.
· Small children must be kept away from the appliance.
· The appliance may only be installed and connected by an authorised
service personal.
· The electrical safety of this hob is guaranteed only if it is connected to a
properly earthed system, which complies with the electrical safety standards.
· Built-in appliances may only be used after they have been built in to
suitable built-in units and work surfaces that meet the standards.
· Do not put pressure on the power supply cable while fitting the hob.
· Power supply cable length should not exceed 2m for isolation safety.
· In the event of faults with the appliance or damage to the glass ceramic
(cracks, scratches or splits), the appliance must be switched off and
disconnected from the electrical supply to prevent the possibility of an electric
shock.
· Repairs to the appliance must only be carried out by authorised service
personal.
· Make sure all the packaging has been removed before you use the
appliance.
· Cables from electrical appliances must not touch the hot surface of the
appliance or hot cookware.
5
. Never leave the the appliance hob unattended when cooking with fat or
oil. They can rapidly catch fire if overheated.
· Do not cut any food on the glass of the vitroceramic hob. Glass panels
should not be used as working surfaces.
· Be careful when using small household appliances, such as irons, near
the elements.
· Do not use the cooking zones with empty cookware or without cookware.
· Make sure all the controls are in the off position when not in use.
· For cleaning, the appliance must be switched off and cooled down.
· For safety reasons, the cleaning of the appliance with steam jet or high-
pressure cleaning equipment is not permitted.
· Use only stable flat-based pans.
· The appliance is not intended for use by persons (including children) with
reduced pyhsical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
· Children should be supervised to ensure that they do not play with appliance.
· Create an opening with the dimensions shown in the picture on next
picture. The distance between the rear edge of the hob and any adjacent
wall is depend on wall surface. please dont use easily combustible material
like curtain, paper at nearby hob.
6
INSTALLATION
The electrical connection of this hob should be carried out by an
authorised service personal or a qualified electrician, according to the
instructions in this guide and in compliance with the current regulations.
· Prior to installation, ensure that the local distribution conditions and the
adjustment of the appliance are compatible.
· The laws, ordinances, directives and standards in force in the country of
use are to be followed (safety regulations, proper recycling in accordance
with the regulations, etc.)
Locating your built-in hob
After removing the packaging material from the appliance and its accessories,
ensure that the hob is not damaged. If you suspect any damage, do not use
the appliance and contact an authorised service personal or a qualified
electrician immediately.
· This built-in hob is to be inserted into a cut out of a worktop. It will be
electrically connected with the switch box below, especially provided for this
purpose.
7
· Apply the one-sided self-adhesive sealing tape supplied all the way round
the lower edge of the cooking surface along the outer edge of the glass
ceramic panel. Do not stretch it.
worktop mounting bracket
· Screw the 4 worktop mounting brackets on the side walls of product.
520mm
590mm
47.5mm
Neighboorhood walls A [mm] B [mm]
Combustible 60 150
Non-combustible 25 40
560mm
490mm
Min. A
Min. B
Min.
130mm
Min.
25mm
8
ELECTRICAL CONNECTION OF YOUR HOB
· Before proceeding with the electrical connection, verify that the current
carrying capacity of the system and the socket is adequate for the maximum
power rating of the hob.
· Electrical installation of the residence and the electrical current plug in
use must be earthed and conform with safety regulations.
· If there is no dedicated hob circuit and fused switch, they must be installed
by a qualified electrician before the hob is connected.
. Fused switch must be easily accessible once the hob has been installed.
· Do not use adaptors, multiple sockets and/or extension leads.
· This appliance conforms with the requirements ofthe following EEC
Directives:
1. Vitroceramic hob EEC/73/23 and 93/68, EEC/89/336 relating to
radio interference,
2. EEC/89/109 relating to contact with foods.
· A circuit breaker with a contact opening of at least 3mm, rated 20A and
delayed functioning type must be installed inside the supply circuit.
· For the knob controlled vitroceramic hob, the cable must be H05VV-F
5X1,5mm² for 3 phase or 3X2,5mm² for single phase / 60227 IEC 53. You
will find the connection diagram shown on the bottom of your appliance.
1
2
3
* This appliance must be earthed.
* For this connetion a power lead of wire type
H05VV-F should be used.
2
2
2
2
2
2
9
· During installation, please insure that isolated cables are used. An incorrect
connection might damage your appliance. The guarantee will not cover such
damages.
· All repairs must be carried out by an authorised service personal or a
qualified electrician.
· Unplug your appliance before each maintenance. For reconnection, follow
the connection diagrams strictly.
· Cooking hobs not provided with supply cord.
Knob controlled cooker is designed for
operating at 6 heat levels:
1 Keeping warm position
2-3 Heating position at low heat
4-5-6 Cooking roasting and boiling
position
Dual and oval heaters have two heating
zones. To activate the outer zone of a
dual/oval heater, turn the knob to
position once. In this way both outer
zones switches on.
To deactivate the outer zone of a
dual/oval heater, turn the knob to
position once. In this way, both outer
zones switches off.
Residual Heat Functions
After all cooking processes there is some
heat stored in the vitroceramic glass
called residual heat. The control can
calculate roughly how hot the glass is
in the worst case. If the calculated
temperature is higher than + 60 ° C,
then this will be indicated in the related
residual heat indicator lamp. The residual
heat display is shown as long as the
calculated heater temperature is > + 60
° C.
10
USAGE
The appliance is operated by using knob control and the heat stored is
confirmed by residual heat indicator lamp on the vitroceramic surface.
After reapplying the supply voltage to the hob control after an interruption of
the supply voltage occurred, causes that the residual heat display flashes,
if the corresponding heater had a residual heat of greater + 60 ° C before
the power interruption occurred. The display will flash until the max. residual
heat time has expired or the heater will be selected and activated.
11
CLEANING AND CARE
Cookware with rough bottoms should not be used since these can scratch
the glass ceramic surface. The bottom of the good cookwares should be as
thick and flat as possible. Before use, make sure that cookware bottoms are
clean and dry.
Always place the cookware on the cooking zone before it is switched on. If
possible, always place the lids on the cookware. Bottom of cookwares must
not be smaller or larger than the cooking zones, they should be at the proper
size as indicated below, not to waste energy.
Before cleaning the hob, first remove the plug from the electrical supply
socket. Then ensure that there is no residual heat stored in the appliance.
Vitroceramic glass is very resistant to high temperature and overheating. If
there is residual heat stored in the appliance, the related residual heat
indicator lamp is on. In order to avoid burns, let the appliance cool down.
Remove all split food and fat with a window scrape. Then wipe the hob with
a suitable washing up liquid and a clean damp cloth. Rub the appliance
using a clean dry cloth.
If aluminium foil or plastic items are accidentally melt on the hob surface,
they should be immediately removed from the hot cooking area with a scraper.
This will avoid any possible damage to the surface. This also applies to sugar
or food containing sugar may be spilled on the hob.
In the event of other food melt on the hob surface, remove the dirt when the
appliance has cooled down. Use cleaner for glass ceramic or stainless steel
when cleaning the surface.
Do not use dishcloth or abrasive sponge to clean the vitroceramic surface.
These materials may damage the surface.
Do not use chemical detergents, sprays or spot removers on the vitroceramic
surface. These materials may cause fire or vitroceramic color fade. Clean
with water and washing up liquid.
CORRECT FALSE FALSE FALSE
The symbol on the product or on its packaging indicates that
this product may not be treated as household waste. Instead it shall
be handed over to the applicable collection point for the recycling
of electrical and electronic equipment. By ensuring this product is
disposed of correctly, you will help prevent potential negative
consequences for the environment and human health, which could
otherwise be caused by inappropriate waste handling of this
product. For more detailed information about recycling of this
product, please contact your local city office, your household
waste disposal service or the shop where you purchased the
product.
