Loading ...
Loading ...
Loading ...
HOWTHEWATERDmSPENSERWORKS
Thewatertank,locatedbehindthedrawersintherefrigerator
compartment,automaticallyfillsaswaterisdispensed.For
properdispenseroperation,therecommendedsupplywater
pressureshouidfallbetween30psiand100psi.
Aftertherefrigeratorisconnectedtothewatersupply,filIthe
watertankbydrawingoneglassofwater._tmaytakeabout
11/2minutesafteractivatingthedispenserpaddlebeforewater
beginstofillthisfirstglass.Continueflushingthesystemfor3
minutestoridthetankandplumbingconnectionsofany
impurities.Thewaterdispenserhasabuiltinshutoffdevice
thatwiIIstopthewaterflowafter3minutesofcontinuoususe.
Simplyreleasethedispenserpaddletoresettheshutoff
mechanism.
HOWTHEICEDISPENSERWORKS-SIDEMOUNTED
Theicemakerandcontainerarelocatedinthetopofthe
freezercompartment.Aftertherefrigeratorisinstalledproperly
andhascooledforseveral
hours,theicemakercan _o,
beginmakingicewithin24
hours.Airinnewplumbing
linesmaycausetheice
makertocycletwoorthree
timesbeforemakingafulI ,_
tray of ice. To begin ice _/__.. /./.
production, lower the wire
signal arm to the "down" or
ON position. With no usage it
wilI take approximately 2
days to fill the ice container.
The ice maker turns off automatically when the ice container
becomes full. To stop the ice maker, lift the wire signal arm until
it clicks, and locks in the "up" or OFF position.
HOWTHE lOB DISPENSER WORKS -REAR MOUNTED
The ice maker and container are located in the top of the
freezer compartment. After the
refrigerator is installed
properly and has cooled for
severa! hours, the ice maker
can begin making ice within
24 hours. Air in new plumbing
lines may cause the ice maker
to cycle two or three times
before making a fulI tray of ice.
Ice production is controlled by
the ice maker's On/Off power
switch. Press the switch to the
"O" position to turn it Off and press it to the "J" position to turn it
On. With no usage it will take approximately 2 days to fill the ice
container. The ice maker also has a built-in wire signal
arm,which automatically stops ice production when the ice bin
is full. This signal arm should not be used to manually stop the
ice maker.
The ice maker produces 4 to 6 pounds of ice every 24 hours
depending on usage conditions. Ice is produced at a rate of 8
cubes every 75 to 90 minutes.
Because of new plumbing connections, the first production of
ice cubes may be discolored or have an odd flavor. These
should be discarded until the cubes made are free of
discoloration and taste.
ICE ANDWATER DISPENSER FEATURES
The ice and water dispenser conveniently dispenses chilled
water, and ice cubes or crushed ice, depending on the model.
To operate the ice dispenser, select the ice option desired
using the touchpad. Press a glass against the dispensing
paddle as far up as possible to catch all ice. To stop
dispensing ice, pull glass away from dispensing paddle. Do
not remove the glass until the ice has completely dispensed.
(Complete instructions for the dispenser operation are
attached to the inside of the freezer door.)
ICE DISPENSER TIPS
,, Ice cubes stored too long may deve!op an odd flavor.
Empty the ice container and ensure that the wire signal
arm is in its "down" or ON position (side mounted) or the
ice maker's On/Off power switch is turned On-set to the '!"
position (rear mounted). The ice maker will then produce
more ice,
,, Occasionally shake the ice container to keep ice
separated.
,, Keep the wire signal arm in its "up" or OFF position (side
mounted) or the ice maker's On/Off power switch turned
Off-set to the "O" position (rear mounted) until the
refrigerator is connected to the water supply or whenever
the water supply is turned off.
12
Loading ...
Loading ...
Loading ...