Loading ...
Loading ...
Loading ...
INSTALL CONTROL BAR
1. Position control bar so flattened sec-
tion with hole is on opposite side of
handle as up-stop bracket.
2. Insert one end of control bar into
handle hole on inside of handle. Care-
fully push in on opposite end of control
bar and insert into hole on opposite
side of handle.
bracket
ASSEMBLE ENGINE ZONE CONTROL
CABLE TO ENGINE
Cable attaches under the brake arm
cover, which is opposite the spark plug
end of engine.
1. Straighten cable and find the end with
the small plastic fitting.
2. Hook the"Z" bend fitting on inner wire of
cable into hole in brake arm of engine.
3. Align the tapered end of the small
plastic fitting with hole in the mounting
bracket and push in until fitting snaps
into place.
"Z" bend cable fittinc
Brake
arm
Small
plastic Mounting
fitting bracket
ASSEMBLE ENGINE ZONE CONTROL
CABLE TO UPPER HANDLE
Assemble cable to opposite side of up-
stop bracket.
1. Route cable below crossbar of lower
handle and up to control bar.
2. Hook "Z" bend fitting on inner wire into
hole in control bar.
3. Attach cable fitting to upper handle as
shown.
4. Secure cable to lower handle with wire
ties.
Upper
handle
Control bar
Up-stop
bracket
ine
zone
control
cable
INSTALL STARTER ROPE
1. Put threaded end of rope guide
through hole in side of upper handle
above lower handle crossbar. Secure
with 1/4-20 Iocknut.
2. Hold control bar against upper handle
and slowly pull engine starter rope
out until rope will slip into loop of rope
guide.
Rope
guide
Engine
starter rope
ASSEMBLE SPARK PLUG BOOT TO
SPARK PLUG WIRE
1. Remove spark plug wire from spark
plug and install boot to wire.
2. Reconnect spark plug wire to spark
plug.
Spark
plug
wire
Boot
Loading ...
Loading ...
Loading ...