Loading ...
Loading ...
Loading ...
INSTAILATIONINSTRUCTIONS
Excessive Weight Hazard
Use two or more people to move and install
freezer.
Failure to do so can result in back or other injury.
Removing packaging materials
• Remove tape and glue residue from surfaces before turning
on the freezer. Rub a small amount of liquid dish soap over
the adhesive with your fingers. Wipe with warm water and
dry.
Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your freezer. For more
information, see the "Freezer Safety" section.
NOTE: This freezer may be installed side by side with another
refrigerator or freezer. Allow for a 3 in. (7.5 cm) clearance at the
top and sides and a 1/4in. (0.64 cm) clearance between the
appliances.
II I
"7
3" (7.5 cm)
When Moving Your Freezer:
Your freezer is heavy. When moving the freezer for
cleaning or service, be sure to protect the floor. Always pull
the freezer straight out when moving it. Do not wiggle or
"walk" the freezer when trying to move it, as floor damage
could occur.
Cleaning before use
After you remove all of the packaging materials, clean the inside
of your freezer before using it. See the cleaning instructions in the
"Freezer Care" section.
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from freezer.
Failure to do so can result in death, explosion,
or fire.
IMPORTANT: Do not install the freezer near an oven, radiator, or
other heat source, nor in a location where the temperature will fall
below 40°F (5°C).
Check the strength of the floor before installing your freezer. It
should hold the weight of a freezer fully loaded with food.
Allow at least 3 in. (7.5 cm) of air space at the top and on both
sides of the freezer and 1 in. (2.5 cm) between the back of the
freezer and the wall. If the freezer is to be against a wall, leave
extra space on the hinge side so the door can open wider.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
Recommended grounding method
A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused, grounded
electrical supply is required. It is recommended that a separate
circuit serving only your freezer be provided. Use an outlet that
cannot be turned off by a switch or pull chain. Do not use an
extension cord.
Loading ...
Loading ...
Loading ...