Broan HVRC1 Mosquito Repellent Cartridge Single Pack

Installation Guide

For HVRC1.

PDF File Manual, 2 pages, Read Online | Download pdf file

HVRC1 photo
DIRECTIONS FOR USE
It is a violation of Federal Law to use this product in
a manner inconsistent with its labeling.
For use outdoors on patios, decks, unenclosed
porches, walkways, around swimming pools and
other areas where mosquito protection is desired.
Do not use indoors.
Do not pry ESD12101 NuTone Haven Repellent
Cartridge open.
For best results install one NuTone Haven unit every
10 feet to 12 feet around the area you wish to protect
from biting mosquitoes.
A set of 4 units provides up to 440 square feet of
mosquito protection.
The Vaporizer works with or without the Light.
The Vaporizer should be turned off when not in use.
The Vaporizer will get hot while in use. Always allow
Vaporizer to cool before replacing with ESD12101
NuTone Haven Repellent Cartridge.
After 6 weeks of use, Open Fixture cover and visually
inspect ESD12101 NuTone Haven Repellent Cartridge
to determine usage rate.
The claimed hours of repellency are an average
based on lab testing, and presume using 90% of
repellent provided. The last 10% of repellent is not
claimed, as repellency effectiveness may diminish
with reduced wick exposure. Your repellent usage
rate will vary based on the temperature and relative
humidity.
The Vaporizer power-on indicator light will flash
when device has been operated for approximately
195 hours, indicating that ESD12101 NuTone Haven
Repellent Cartridge has about 20 hours remaining
of effective operating life. We recommend that
you check the ESD12101 NuTone Haven Repellent
Cartridge and replace it before it is empty, or when
you notice increased mosquito activity.
Replace when ESD12101 NuTone Haven Repellent
Cartridge is empty.
Replace ESD12101 NuTone Haven Repellent
Cartridge when power to device is off.
Do not use anything other than ESD12101 NuTone
Haven Repellent Cartridge in the NuTone Haven
Fixture.
OPERATING INSTRUCTIONS
Use transformer or optional controller to operate
Vaporizer.
Use transformer or optional controller to operate
Light.
Use with 12v transformer and controller available
separately.
INSTALLATION INSTRUCTIONS
Turn off electricity at main circuit breaker panel
before beginning installation. Consult local building
codes to ensure compliance with wiring and ground-
ing requirements.
1. Attach each Fixture to post or stem, using
hardware provided making sure Fixture is level.
Fig. 1.
2. Connect Vaporizer and Light wires to controlled
12v power source, or use NuTone Haven
Controller and Transformer.
3. Install one ESD12101 NuTone Haven Fixture every
10 to 12 feet.
If you have any questions about wiring, get
assistance from a professional electrical contractor.
Fig. 2
SPURS
AT
BOTTOM
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 3
Fig. 1
FOR FIRST TIME USE:
HOW TO INSERT ESD12101 NUTONE HAVEN RE-
PELLENT CARTRIDGE INTO FIXTURE.
1. Remove 1 (one) ESD12101 NuTone Haven
Repellent Cartridge from packaging.
2. Place on a flat surface and remove protective cap.
Fig. 2.
3. Attach locking adaptor cap to bottle with spurs at
bottom, closest to bottom of bottle, and turn until
secure. Once attached properly, this cap is not
removable. Fig. 3.
4. Disconnect power to Fixture. Fig. 4.
5. Open Fixture cover. Fig. 5.
6. Ensuring that the locking adaptor cap is secured to
the Repellent Cartridge, carefully insert ESD12101
NuTone Haven Repellent Cartridge into fixture so
that top of wick fits into Vaporizer and rotate about
30 degrees to secure to fixture. Fig. 6.
7. Replace Fixture cover. Fig. 7.
8. Repeat for each Fixture.
9. When finished, reconnect power.
HOW TO REPLACE EMPTY ESD12101 NUTONE
HAVEN REPELLENT CARTRIDGE INTO FIXTURE.
1. Disconnect power to Fixture. If Vaporizer has
been operating, allow at least 1 hour to cool down
before handling. Fig. 4.
2. Remove 1 (one) ESD12101 NuTone Haven
Repellent Cartridge from packaging.
3. Place on a flat surface and remove protective cap.
Fig. 2.
4. Attach locking adaptor cap to bottle with spurs at
bottom, closest to bottom of bottle, and turn until
secure. Once attached properly, this cap is not
removable. Fig. 3.
5. Open Fixture cover. Fig. 5.
6. Remove used ESD12101 NuTone Haven Repellent
Cartridge from assembly.
7. Ensuring that the locking adaptor cap is secured to
the Repellent Cartridge, carefully insert ESD12101
NuTone Haven Repellent Cartridge into fixture so
that top of wick fits into Vaporizer and rotate about
30 degrees to secure to fixture. Fig. 6.
8. Replace cover. Fig. 7.
9. Repeat for each Fixture.
10. When finished, reconnect power.
STORAGE AND DISPOSAL
Do not contaminate water, food, or feed by storage
and disposal of repellent unit.
Pesticide Storage: Store in a cool, dry place. Keep
container tightly closed. Store refills out of direct
sunlight.
Pesticide Disposal and Container Handling:
Non-refillable cartridge. Do not reuse or refill this
cartridge. If empty or at the end of the season,
dispose of unused portion according to label
directions: Place in trash. If partly lled: Call your
local solid waste agency for disposal instruction.
Never place unused product down any indoor or
outdoor drain.
Keep Out of Reach of Children
CAUTION
EPA Reg. No. 1021-2618-90291
EPA Est. No. 90291-WI-1
99528687B
Loading ...

Other documents for Broan HVRC1

The following documents are available:
Installation Instruction Other Documents Photos

Specifications

See other models: HVRC4 NU230BL AR80MB L100E NW330SS