Loading ...
Loading ...
Loading ...
Page 10
4. Installation
2. Wall Installation
This type of installation is similar to roof mounting, ensuring that the pipe extends at least 55mm past the wall
surface refer gure 3. If the pipe length is shortened, reproduce the power cord exit slot on the inside of the
wall.
NOTE: By decreasing the length of the duct from which specied (refer to installation instructions) there will
be an increase in airow and noise levels as a result. This increase in airow can cause movement of air to be
heard through the system and inhibit the system to run silently.
Figure 2 Wall installation
Wall
Backdraft Shutter*
200mm Metal Pipe
From outside face of wall cover plate to end of
pipe (or wall if cover plate not used)
28
Locking screws
Power cord to
220-240V supply
Fill gap between pipe and
wall or t second wall cover
plate if required
Motor
Wall cover plate (optional)**
Weather shield
must be at top
IMPORTANT
It is a requirement to use the wall hanging bracket for all wall mount
installations. Please refer to the illustrations for mounting.
* With through wall installations ap shaft will be close to vertical.
** Optional parts are available from Schweigen, please contact 1300 881 693.
Wall
Loading ...
Loading ...
Loading ...