Loading ...
Loading ...
Loading ...
SLEEP FEATURE:
TO ADJUST FAN SPEEDS:
Page 31
Press Sleep button to initiate the sleep mode.
In this mode the selected temperature will
increase (cooling) or decrease (heating) by 2
°F/1
(or 2)
°C 30 minutes after the mode is selected.
The temperature will then increase (cooling) or
decrease (heating) by another 2
°F/1 (or 2)°C
after an additional 30 minutes. This new
temperature will be maintained for 6 or 7 hours
before it returns to theoriginally selected
temperature. This ends the Sleep mode and the
unit will continue to operate as originally
programmed. The Sleep mode program can be
cancelled at any time during operation by pressing
the Sleep button again.
TO SELECT THE OPERATING MODE:
To choose operating mode, press Mode button.
Each time you press the button, a mode is
selected in a sequence that goes from Auto,
Cool, Dry ,heat(cooling only models without)and
Fan. The indicator light beside will be illuminated
and remained on once the mode is selected.
The unit will initiate automatically the Energy
Saver function under Cool, Dry, Auto(only
Auto-Cooling and Auto-Fan) modes.
To operate on COOL mode:
• Choose Cool Mode to set the cooling function.
Use the Up and Down buttons to choose the
desired temperature. When Cool Mode is
selected, the fan speed can be adjusted by
pressing the fan button.
To operate on HEAT mode(cooling only models
without):
• Choose Heat Mode to set the heating function.
Use the Up and Down buttons to choose the
desired temperature .When heat Mode is selected,
the fan speed can be adjusted by pressing the
fan button.
NOTE: For some models, the fan speed can not
be adjusted under HEAT mode.
FOLLOW ME FEATURE:(on some models)
This feature can be activated from the remote
control ONLY. The remote control serves as a
remote thermostat allowing for the precise
temperature control at its location.
To activate the Follow Me feature, point the
remote control towards the unit and press the
Follow Me button. The remote display is actual
temperature at its location. The remote control
will send this signal to the air conditioner every
3 minutes interval until press the Follow Me
button again.If the unit does not receive the
Follow Me signal during any 7 minutes interval,
the unit will beep to indicate the Follow Me
mode has ended.
Press Fan button to select the Fan Speed in four
steps-Auto, Low, Med or High. Each time the
button is pressed, the fan speed mode is shifted.
For some models, the fan speed can not be
adjusted.
CHECK FILTER FEATURE:
Press Check lter button to initiate theis feature.
This feature is a reminder to clean the Air Filter for
more ecient operation. The LED(light) will
illuminate after 250 hours of operation. To reset
after cleaning the lter, press the Check Filter
button and the light will go o.
ENERGY SAVER FEATURE:
Press Energy saver button to initiate this function.
This function is available on COOL, DRY, AUTO
(only AUTO-COOLING and AUTO-FAN) modes.
The fan will continue to run for 3 minutes after
the compressor shuts o.The fan then cycles on
for 2 minutes at 10 minute intervals until the
room temperature is above the set temperature,
at which time the compressor turns back on and
Cooling Starts.
Light flashes or
illuminates
Follow
Me
Loading ...
Loading ...
Loading ...