Loading ...
Loading ...
Loading ...
Style 2
1
I
2
1. Tube Clamp
2. Copper Tubing
3, Compression Nut
The ice maker is equipped with a built-in water strainer.
If local water conditions require periodic cleaning or a
well is your source of water supply, a second water
strainer should be installed in the 1A-inch water line.
Obtain a water strainer from your nearest appliance
dealer. Install at either tube connection.
4. Plug in refrigerator or reconnect power.
%' the ©oot s
TOOLS NEEDED:
_46-inch hex-head socket wrench, No. 2 Phillips
screwdriver, flat-head screwdriver, 1/2-inchopen-end
wrench, flat 2-inch putty knife.
5/16inch Hex-Head Hinge Screw
Door Stop Screw
Sealing Screw (useon top of doors)
To remove doors from hinges:
1. Keep doors closed until ready to lift free from the
cabinet.
2. Start at the top hinge and work your way down to the
center hinge and bottom hinge. Remove all screws and
components as shown.
3. Open and lift doors off hinges.
NOTE: If you are reversing the door swing, you should
move the handles while the doors are off of the refrigerator.
Follow the instructions in the "Reversing the Door
Handles" section.
To replace doors on hinges:
1. Remove hole plugs covering the screw holes on the
opposite side of the refrigerator using a flat putty knife.
2. Replace the doors.
3. Start at the bottom hinge and work your way up to the
center hinge and top hinge replacing all components
and screws as shown.
4. Line up doors so they are centered between the sides
of the cabinet and parallel with each other.
5. Fill all unused openings with screws or plastic hole
plugs. Moisture will enter any unfilled openings.
NOTE: If the doors are not closing on their own, see
the "Door Closing and Alignment" section.
Top Hinge
1.Hex-Head Hinge Screws
2. Top Hinge
3, Spacer
4, Sealing Screws
SU66ESTION: Reversing the door swing should be
performed by a qualified person.
IMPORTANT: Before you begin, turn the refrigerator OFF,
unplug it, and remove any food from door shelves.
Loading ...
Loading ...
Loading ...