Loading ...
Loading ...
Loading ...
— 15 —
STEP 4
Gas Connection
For NG, input pressure is 7” W.C. and output pressure 5” W.C.
For LP, input pressure is 11” W.C. and output pressure: 10” W.C.
Appliance regulator is set at 5.0” W.C. outlet pressure.
The gas supply pressure for checking the regulator setting is 5” (Natural Gas) and 10” (LP gas). Connect exible gas line
connector to the regulator on the range. Position range to permit connection at the shut off valve.
DANGER:
The gas supply line must be equipped with an approved manual shut-off valve. The shut-off valve must be in an easily
accessible location in the same room as the appliance. Do not block access to the shut-off valve. Be sure you know
how and where to shut off the gas supply to the range.
STEP 3
Dimensions and Clearances
• Before installing the range, you must locate and secure
the included anti-tip bracket to the wall for your range.
• The range may be installed ush to the rear wall. You
may install a non-combustible material on the rear
wall above the range and up to the vent hood. It is not
necessary to install non-combustible materials behind
the range below the countertop height.
• The minimum distance from the side of the range above
the countertop to combustible sidewalls must be at
least 10 inches.
Installation
30”(76.2 cm) Min.
36”(91.4 cm) Max.
18” (45.7 cm) Min.
13” (33 cm) Max.
36” (91.4 cm)
1/4”
(0.6 cm)
Figure 3
The pressure regulator located at the inlet of the appliance manifold must remain in the supply line regardless of Natural
(NG) or Liquid Propane (LP) gas is being used.
A exible metal appliance connector used to connect the appliance to the gas supply should be 3 feet/91.4 cm max. in
length for easy installation. In Canada, exible connectors should be single wall metal connectors less than 6 feet/182.9 cm
in length.
Loading ...
Loading ...
Loading ...