Loading ...
Loading ...
Important Safety
Instructions (continued)
Other Precautions
•Never unplug the refrigerator bypulling on the powercord. Always grip the plug
firmly, and pull straight out from the receptacle.
• To avoid electrical shock, unplug the refrigerator before cleaning and before
replacing a light bulb. NOTE: Turning the control to OFFturns offthe compressor,
but doesnot disconnect power to the light bulb or other electricalcomponents.
• Do not operate the refrigerator in the presence of explosive fumes.
• Avoid contact with any moving parts of the automatic ice maker.
First Steps
Adjusting Front Rollers
Replacing Toe Grille
This Owner's Guide provides specific operating instructions for your model. Use
refrigerator only asinstructed inthis Owner's Guide. Before starting refrigerator,
follow these important first steps:
Location
Install refrigerator:
• nearagrounded electricaloutlet. DO NOT useanextensioncordor an adapter plug.
• out of direct sunlight and away From range, dishwasher, or other heat sources,
if possible.
• on a Floorthat islevel and strong enough to support aFully loaded refrigerator.
• where a water supply is available for automatic ice maker.
Installation
• Do not install refrigerator where temperature will drop below 60°F (15°C), or
rise above 110°F (43°C). Compressor will not be able to maintain proper
temperatures.
• In a recessed installation, allow an extra 1/2 inch (10-15 mm) on each side for
ease of installation.
• If the hinge side of the unit will be placed against a wall, allowa 1-3/4 inch (44
mm) space between wall and refrigerator to permit proper door swing.
Door Opening
For best use of drawers and freezer baskeL refrigerator should be in a position
where both the refrigerator and Freezer doors can be opened about 135 °
Leveling
• Refrigerator must be leveled with all bottom corners resting Firmly on a solid
Floor. Adjust Front rollers to level cabinet both front-to-rear and side-to-side.
Keep cabinet aslow aspossible for stability. Never a(_ust cabinet rollers so front
is lower than rear.
• To adjust front rollers: Open refrigerator and Freezerdoors. Removetoe grille
by pulling it straight out. Adjust rollers by turning each roller adjusting bolt with
an adjustable wrench, a socket wrench, or a nutdriver until refrigerator islevel
and stable. Rear rollers are not adjustable.
• Check both doors to be sure seals touch cabinet evenly on all Foursides.
• IfFreezerdoor ishigher than refrigerator door, raiseright corner and/or lower left
corner until doors align across top of cabinet.
• If refrigerator door ishigher than Freezerdoor, raise left corner and/or lower right
corner until doors align acrosstop of cabinet.
• To replace toe grille: Line up tabs with holes, and push grille straight on.
Cleaning
• Wash the inside, all removable parts, and the outside with mild detergent and
warm water. Wipe dry. Do Not Use Harsh Cleaners On These Surfaces.
• Do Not use razor blades or other sharp instruments that can scratch appliance
surface, when removing adhesive labels. Any glue left From the tape or energy
label can be removed with a mixture of warm water and mild detergent, or touch
glue with sticky side of tape already removed.
•Do Not remove Serial Plate.
Loading ...
Loading ...
Loading ...