Loading ...
Loading ...
Loading ...
General Care & Cleaning (cont'd)
Removing and Replacing Warmer (Warm & Ready TM) Drawer
Electrical Shock Hazard can occur and result
in serious injury or death. Disconnect appliance from electric
power before cleaning and servicing the warmer drawer.
To Remove Warmer Drawer:
1. _ Turn power off before removing the warmer drawer.
2. Open the drawer to the fully opened position.
3. Locate glide lever on each side of drawer, pull up on the left glide lever
and push down on the right glide lever (See Figure 1).
4. Pull the drawer away from the range.
To Replace Warmer (Warm & Ready TM) Drawer:
1. Pull the plastic slider to the front of the glide slots on each side of
the drawer cavity (See Figure 2).
2. Align the glide on each side of the drawer with the drawer cavity glide
slot.
3. Push the drawer into the drawer cavity until glide levers "click"
(approximately 2"). If you do not hear the glide levers "click" or the
drawer does not feel seated remove the drawer and repeat steps 1
thru 3.
Note: The Warmer Drawer will NOT operate while in the "Self-Clean" and
"Oven Lockout" modes
Pull up lever
with finger
Pull down lever
with finger
Figure 1
Right Glide
Figure 2
Changing the Oven Light
il
//
Be sure the oven is unplugged and all parts are COOL before replacing the oven
light bulb. Do not turn the oven light on during the self-cleaning cycle. High temperature will
reduce lamp life.
The interior oven light will turn on automatically when the oven door is opened.
The oven light may be turned on when the door is closed by using the oven light switch
located on the control panel.
On a self clean oven the lamp is covered with a glass shield held in place by a wire holder.
THIS GLASS SHIELD MUST BE IN PLACE WHENEVER THE OVEN IS IN USE.
To replace the light bulb:
CAUTION: BE SURE OVEN IS COOL
1. Turn the power off at the main source.
2. Wear a leather-faced glove for protection against possible broken glass.
3. Replace bulb with a 40 watt appliance bulb only.
4. For self-cleaning oven, press wire holder to one side to release glass shield,
change bulb and be sure to replace glass shield.
45
Loading ...
Loading ...
Loading ...