Loading ...
Loading ...
Loading ...
INSTALLATION
Check the appliance is electrically safe and gas sound when you have nished.
34
Range operational checks
Oven check
Turn on the oven and check that the oven fans start to turn
and that the oven starts to heat up. Turn o the oven.
Oven light
Press the oven light switch and check that the lights are
working.
NOTE: The oven light bulbs are not included in the warranty.
Check ignition of cooktop burners
Operation of all cooktop burners should be checked after the
range and gas supply lines have been carefully checked for
leaks.
There is a ame safety device that stops the ow of gas to
the burner if the ame goes out. There is also a spark ignition
system that works when the knob is pressed in.
For each burner, push in and turn a knob to the lighting
position.
Keep holding the knob pressed in to let the gas through to
the burner for a few seconds.
If, when you let go of the control knob, the burner goes out,
the safety device has not held in. Turn the control to the
o position and wait one minute, then try again this time
holding in the control knob for slightly longer.
Quality of flames
If the ame is distorted, check that the burner head is
correctly placed over the burner base.
MAKE SURE THE FLOW OF COMBUSTION AND
VENTILATION AIR TO THE RANGE IS UNOBSTRUCTED.
MAKE SURE ALL CONTROLS ARE LEFT IN THE OFF
POSITION.
Customer care
Please complete your details in the table at the end of the
‘Using your Range’ section of this guide.
Place these instructions into the colored CornuFé folder in the
instruction pack and hand them to the user.
Thank you.
How to move the range for
servicing
Follow these procedures to remove appliance for servicing:
• Shut off the gas supply and turn off the circuit breaker.
• Disconnect gas supply tubing to appliance and unplug
the electrical supply cord.
NOTE: A suitably qualied person should disconnect and
reconnect the gas supply.
Take great care. We recommend two people maneuver the
range. Make sure that the oor covering is rmly attached,
or removed to prevent it being disturbed when moving the
range around.
Before attempting to move the range, see “Moving the
range”.
Replacing the range
Reverse procedure to reinstall. If the gas line has been
disconnected, check for gas leaks after reconnection.
NOTE: A suitably qualied person should disconnect and
reconnect the gas supply.
The service engineer MUST follow installation instructions
provided with the gas appliance connector and the warning
label attached to the connector.
Failure to take this precaution could result in tipping of the
range and cause injury.
Replace the storage drawer and door.
Loading ...
Loading ...
Loading ...