Loading ...
Loading ...
Loading ...
9. At this time, make sure all gas, exhaust and electrical connections are complete. Plug
dryer in, and check operation by using the checklist below.
10. (GAS MODELS ONLY) - The burner may not ignite initially due to air in the gas line.
Allowing the dryer to operate on a heat setting will purge the line. If the gas does not ignite
within five minutes, turn the dryer off and wait 5 minutes. Be sure the gas supply to the
dryer has been turned on. In order to confkrm gas ignition, check the exhaust for heat.
FINAL INSTALLATION CHECK LIST
- Dryer is plugged into electrical outlet and is properly grounded.
- Exhaust ductwork is hooked up and joints taped.
- Plastic flexible duct is NOT used.
- Use only rigid or stiff wailed flexible metat vent materia!.
- Dryer is level with at1 legs firmty on the floor, with the lock nuts tightened.
- Vinyl feet have been installed.
- Gas Models - Gas is turned on, there are no gas leaks.
- Dryer runs.
- Dryer heats.
- Dryer shuts off.
- Demonstrate use to customer.
PARTS AND LITERATURE ARE PACIC GED 4SIDE
OF DRYER DRUM