Loading ...
Loading ...
Loading ...
38 39
Operation with Logic Pro
Once iD14 has been successfully installed
following the steps detailed after page 11
of
this manual, launch Logic Pro and check the
following:
Logic Pro > Preferences > Audio
Ensure that iD14 is selected as the active
audio device and set the buer size (to aect
system latency). If you are experiencing issues
with playback stability and CPU loading, try
increasing the buer size. This appears with
“overload” errors and/or pops and clicks and
distortion in the audio.
Logic Pro Setup
If you are using the iD mixer to monitor input
signals while recording, be sure to disable
Logic’s software monitoring to avoid phasing
as the same source will be heard twice with
a short delay between the low latency DSP
signal and the delayed software monitoring
signal.
Assigning I/O
All of iD14’s input and output channels will
be available to Logic for routing. There are
a total of 10-inputs and 6-outputs reported
from the driver.
You can rename input and
output channels to whatever you wish using
the I/O label function. This is a great way to
keep things organised.
Mix > I/O Labels
Go to Setup > I/O... to label your inputs and
outputs and ensure that iD14 is correctly
reporting 10-inputs and 6-outputs to and
from Pro Tools.
For more Pro Tools information consult your
Avid user manuals & documentation.
Operation with Pro Tools
If using Windows, ensure that you have
followed the installation instructions found on
page 11
.
With iD14 connected, launch Pro Tools and
ensure that a new session is created at
the desired sample rate. If you are using
Windows, make sure that you have already
set your Latency and Buer Size settings in
the iD System Tray before opening a project.
Changing these mid session will result in Pro
Tools needing to restart.
Playback Engine
Go to Setup > Playback Engine... and ensure
that iD14 is set as the active playback
device.
Pro Tools Setup
Loading ...
Loading ...
Loading ...