Loading ...
Loading ...
Loading ...
3W
SQUARE PANEL
80*80
(75-80mm)
110*110
(105-110mm)
155*155
(150-155mm)
205*205
(200-205mm)
280*280
(275-280mm)
6W 12W 18W 24W
INSTALLATION
HOLE SIZE
1.Cut a hole using an appropriate tool
according to the cut-out size.
4. Check whether the lamp is flat and electrified.
5. Clean the lamp with clean cloth.
6. Switch on the power and test the light.
3. Hold the two clips back against the panel light and push it
into the hole. Allow the springs to pull the light up to the ceiling.
2.Switch OFF the power & Connect
AC: 220-240V voltage with terminals.`
4.Press the buckle outwards,
remove the aluminum substrate
pressing strip from the bayonet,
and remove the pressing strip.
This step is only required for
24W panel light, other items are
not required.
5.Press the buckle outwards,
remove the aluminum substrate
from the buckle, and remove
the light source board.
6.Take out two-cord cable (wire diameter
18-22AWG) and insert it into the plug-in
terminal. Connect the external power
supply for testing.
1.Power o, tap the central area of the
diusion plate with a pointed tool, and
take out the cracked diusion plate
2.Remove the power wire from the
plug terminal
3.If there is no hot melt column in the
lamp body or the hot melt column is
not hot melt,this step will be adjusted
without treatment.If the hot-melt column
has been fused to fix the aluminum
substrate,cut the hot-melt part of the
hot-melt point with diagonal pliers.
DISASSEMBLY DIAGRAM
IN CASE OF ANY QUERY/ISSUE WITH THE PRODUCT, PLEASE REACH OUT TO US AT: SUPPORT@V-TAC.EU
FOR MORE PRODUCTS RANGE, INQUIRY PLEASE CONTACT OUR DISTRIBUTOR OR NEAREST DEALERS. V-TAC
EUROPE LTD. BULGARIA, PLOVDIV 4000, BUL.L.KARAVELOW 9B