Loading ...
Loading ...
Loading ...
Six-Speed
Cable Slot
Control
Arm
Figure 24
•Make sure the belt is routed inside the pulley halves
and the belt guard pin.
• Reinstall the bolt securing transmission to rear
mower housing.
• Pivot the baffle back to its original position and
secure with three hex screws removed earlier.
• Lightly lubricate the inside of the blade adapter and
reinstall the blade adapter, blade, and blade bell
support in the correct order.
• Tighten the hex bolt to secure the blade to torque:
450-600 in. Ibs.
ReplacingRearFlap
• To remove rear flap, cut off the flat end of the wire
rod which secures itto the deck.
• Attach the new flap and new rod to deck, bending
the ends of the new rod over to secure to deck.
SECTION9: OFF-SEASONSTORAGE
StoringYourLawnMower
The following steps should be taken to prepare your
lawn mower for storage.
• Clean and lubricate mower thoroughly as described
in the lubrication instructions.
IMPORTANT:We do not recommend the use of a
pressure washer or garden hose to clean your unit.
• Refer to engine manufacturer's manual at the end
of this manual for correct engine storage
instructions.
• Coat mower's cutting blade with chassis grease to
prevent rusting.
• Store mower in a dry, clean area. Do not store next
to corrosive materials, such as fertilizer.
NOTE: When storing any type of power equipment in a
poorly ventilated or metal storage shed, care should be
taken to rust-proof the equipment. Using a light oil or
silicone, coat the equipment, especially cables and all
moving parts.
16
Loading ...
Loading ...
Loading ...