Greenworks MO48L4210 2 x 24V 48V 20" Brushless Cordless Push Lawn Mower, 2 4.0Ah USB Batteries USB Hub and Dual Port Rapid Charger Included

User Manual - Page 12

For MO48L4210.

PDF File Manual, 44 pages, Read Online | Download pdf file

MO48L4210 photo
Loading ...
Loading ...
Loading ...
9.3 STORE THE MACHINE
Remove the safety key.
Remove the battery pack(s).
Clean the machine before storage.
Make sure the motor is not hot when you store the
machine.
Make sure that the machine does not have loose or
damaged parts. If it is necessary, follow these
instructions:
Replace the damaged parts.
Tighten the bolts.
Speak to a person at an approved service center.
Store the machine in a dry area.
Make sure that children cannot come near the machine.
9.4 VERTICAL STORAGE
1. Remove the grass catcher.
2. Remove the battery and safety key.
3. Pull through the handle holes to fold away the handles.
4. Lock the handles into position.
5. Stand the machine on end and make sure that the brackets
touch the floor.
10 TROUBLESHOOTING
Problem Possible cause Solution
The handle is not
in position.
The bolts are not
engaged correctly.
Adjust the height
of the handle and
make sure that the
bolts and nuts are
aligned correctly.
The machine does
not start.
The battery ca-
pacity is low.
Charge the battery
pack.
The start handle is
defective.
Replace the start
handle.
The battery key is
not put in.
Put in the battery
key.
The machine cuts
grass unevenly.
The lawn is rough. Examine the mow-
ing area.
The blade height is
not set correctly.
Move the wheels
to a higher posi-
tion.
The machine does
not mulch correct-
ly.
Wet grass clip-
pings attach to the
deck.
Wait until the
grass dries before
mowing.
The mulch plug is
missing.
Install the mulch
plug.
The machine is
hard to push.
The grass is too
tall, or the blade
height is too low.
Increase the blade
height.
The grass catcher
and the blade
drags in thick
grass.
Empty the grass
clippings from the
grass catcher.
There is a high vi-
bration in the ma-
chine.
The blade is un-
balanced and
worn.
Replace the blade.
The motor shaft is
bent.
1. Stop the mo-
tor.
2. Remove the
safety key and
battery pack.
3. Disconnect the
power source.
4. Inspect for
damage.
5. Repair the ma-
chine before
you start it
again.
12
English
EN
Loading ...
Loading ...
Loading ...