Loading ...
Loading ...
Loading ...
13
OPERATING INSTRUCTIONS
• The power washer will pull a ratio of water to
detergent of 10:1 or 10 parts water to 1 part
detergent. The detergent concentration can be
adjusted by turning the detergent knob on the top of
the machine. Turn it left for more concentration or
turn it right for less concentration.
Operation Tips
• Note:
Test the GFCI (For US unit only) before each use:
1. Plug GFCI into power outlet. Indicator should turn
green to show that cord has power.
2. Press test button, green indicator should turn off
to verify that GFCI cut off power to the cord.
3. Press reset button – green indicator should turn
on to show that cord has power again.
4. When GFCI is working properly, green indicator will
turn on when power is applied. If green indicator
turns off, it has detected electric leakage and the
GFCI cut off power to the appliance.
• If you hear the motor run intermittently when the
trigger is not being squeezed, that is normal.
The pump is priming itself so it is ready to operate
when the trigger is squeezed. Turn off the power
washer if not being used after ve minutes.
• The o-rings on the bayonet end of the nozzle should
be cleaned regularly and lubricated with non-water
soluble grease such as petroleum jelly (not included).
• Keep the nozzle cleaning wire for use in unclogging
the nozzle. If you lose the cleaning wire, a
straightened paper clip also works.
How to Avoid Damaging Surfaces
• Damage to surfaces being cleaned occurs because
the impact force of the water pressure exceeds
the durability of the surface. Bare wood can be
penetrated, paint can be peeled off, etc. You can vary
the force of your power washer by controlling:
1. The angle of the surface being cleaned.
2. The distance of the nozzle from the surface being
cleaned.
• Never use a narrow high pressure stream of water on
soft surfaces susceptible to damage.
• Use the 25˚ quick connect nozzle when cleaning
windows. Squeeze the trigger and vary the spray
pattern and angle until optimum cleaning efciency is
achieved.
Using Power Cord
• Remove the power cord from the unit by swiveling the
cord hook to the up or down. The power cord then can
be slid off to the side of the power washer unit.
• Swivel cord hook back to left or right when ready to
wrap the cord back into place for storage.
Loading ...
Loading ...
Loading ...