Loading ...
Loading ...
Loading ...
14
Locate the guard onto the motor housing and turn it a bit to make sure it engages into the slots on the
motor housing. Note to follow the arrow direction on the guard. Then fix the guard onto the motor
housing with the screw out of the package (See fig.6 and fig.7).
When in edging mode, the edger wheel needs to be fit on the trimmer. Insert the edger wheel into the
black slot piece on the motor housing (See fig.8). Make sure the edger wheel is firmly connecting
with slot. And push the guide wire to make it not protrude.
CONNECTING AND REMOVING BATTERY
IMPORTANT!
The battery pack is not charged when it is purchased. Before using the power tool for the first time, place
the battery pack in the battery charger and charge. Make sure to read all safety precautions, and follow the
instructions in the battery charger section.
To install the battery pack
To install the battery pack into the bottom of the handle, align the rails of the battery pack with the rails in
the handle and push the battery into the handle. To connect the battery, slide the battery pack fully
forward. Until the latch locks into place.
To remove the battery pack
Press the battery release button ,Slide the battery pack backward, and then pull or lift the battery out of
the tool .
WARNING:
Follow these instructions in order to avoid injury and to reduce the risk of electric shock or
fire:
• Replace the battery pack or the charger immediately if the battery case or charger cord is damaged.
• Verify that the battery pack is removed before inspecting, adjusting, or performing maintenance on
any part of the power tool.
• Read, understand, and follow the instructions.
Fig.8
Fig.6 Fig.7
Loading ...
Loading ...
Loading ...