RCF TT 1-A II OWNER MANUAL

Loading ...

ENGLISH

REAR

PANEL

FEMALE XLR INPUTS (BAL/UNBAL). The system accept XLR input connectors.

MALE XLR SIGNAL OUTPUT. The output XLR connector provides a loop through for speakers

daisy chaining. The balanced connector is connected in parallel and can be used to send the

audio signal to other ampliﬁed speakers, recorders or supplementary ampliﬁers.

SYSTEM SET UP ENCODER. Push the encoder to select a function (gain reduction, delay,

preset). Rotate the encoder to select a value or a preset.

GAIN REDUCTION LED. Pushing the encoder once the gain reduction indicator lights green.

Then rotate the encoder to reduce the gain to the right level.

DELAY LED. Pushing the encoder twice the delay indicator lights green. Then rotate the

encoder to delay the speaker. The delay is expressed in meters.

PRESET LED. Pushing the encoder three times the preset indicator lights green. Then rotate

the encoder to load the right preset to the speaker.

SYSTEM SET UP DISPLAY. Display the system setting values. In case of RDNet active

connection a rotating segment will light up.

RDNET LOCAL SETUP/BYPASS. When released the local setup is loaded and RDNet can only

monitor the speaker. When switched the RDNet setup is loaded and bypass any speaker local

preset.

RDNET RECALL LED. This orange LED lights up when the LOCAL SETUP/BYPASS switch is

pressed. If connected, RDNet is taking control of the speaker the speaker.

RDNET IN/OUT PLUG SECTION. The RDNET IN/OUT PLUG SECTION features etherCON

connectors for the RCF RDNet protocol. This allows the user to completely control the speaker

using the RDNet software.

LIMITER LED. The ampliﬁer has a built in limiter circuit to prevent clipping of the ampliﬁers

or overdriving the transducers. When the soft clipping circuit is active the LED blinks RED. It is

okay if the limit LED blinks occasionally. If the LED lights continuously, turn down the signal level.

Loading ...

RCF TT 1-A II ACTIVE TWO-WAY SPEAKER