Loading ...
Loading ...
3. Click the setting button on the control panel and select the setting target, a.
The vacuum time is generally set to 30-40S. Click the increase or decrease button
to set the ideal vacuum time. b. Sealing time: Click the set button twice, the
sealing time is generally set to 1.5-2S, and the sealing time is set according to
the thickness of the vacuum bag. It is forbidden to set the sealing time too long
and burn the sealing heating bar. c. After the sealing time is set, click the set
button again to set the cooling time, usually 3-5S. After the cooling time is set,
click the set button, and the control panel will display the letter E. d. The setting
process is over.
4. Put the product to be packaged in the working room of the machine, open the
pressure bag, place the vacuum bag mouth flat on the sealing strip, put back the
pressure bag, and cover the vacuum machine lid, which needs to be pressed by
hand during operation.Click the start button on the front end of the vacuum
machine cover. Once the vacuum machine starts to work, the vacuum meter will
begin to run. If the pointer of the vacuum gauge does not move after the machine
starts, you will need to apply a little pressure to the front of the vacuum machine
cover until the guage moves.After the vacuum meter pointer starts to run, you
can remove your hand from the cover. The machine will automatically complete
the packaging process afterward. The product and the vacuum bag must match
each other. The packaged product needs to be filled with a vacuum bag to achieve
a good vacuum effect.If a larger vacuum bag packs a smaller product, the
vacuum will not reach optimal performance.The vacuum bag must be filled with
the product to be packaged to present a good vacuum effect.
Four. Common Faults and Solutions
1. The control panel shows that there is no power: Check whether the wires of the
internal power input part of the machine are loose or have fallen off.
2. The vacuum pump is not working: The control panel is working and running.
The vacuum pump is not rotating. Check whether the vacuum pump power supply
wire is loose or falling off.
4. The air in the vacuum bag cannot be pumped out: The vacuum time is not
enough. Prolong the vacuum time, and ensure that the product in the vacuum
bag fills as close as possible to the sealing strip.
5. After the packaging process, the vacuum lid does not open: Check and repair
the air release solenoid valve.
3
Loading ...