Loading ...
Loading ...
Loading ...
5
6. It is recommended to use metal/aluminum duct/pipe with a
uniform size (ex. 6” round pipe from range hood to the outside).
7. If an elbow is necessary, a minimum of 12” straight run is
necessary before the elbow.
Clearance
8. Clearance is the distance between the cooktop and the bottom
of the range hood. The recommended minimum clearance for
this model is 26” and the maximum clearance is 30”.
9. It is important to install the hood at the recommended
clearance. Installing too low could result in damage and/or fire
hazard while installing too high may result in reduced
performance and efficiency.
Hood Installation
10. The first step is to secure the mounting screws on the wall. It is
important that the screws are touching the wall studs. If
necessary, install a cross lumber frame in the wall as shown in
Figure 1.
11. Attach the mounting screws on the wall, leaving about 1/8 of an
inch between the wall and the end point of the screws since this
is where you will hang your hood. Refer to Figure 2.
12. Remove the four screws from top of the hood body. Position
and install the glass canopy onto the hood body with the four
screws.
13. Align the hood-mounting bracket to the screws on the wall and
hook into place. Then tighten the screws to secure the hood to
the wall.
CAUTION: MAKE SURE THE HOOD IS SECURE BEFORE
RELEASING.
Ductwork
14. Connect the pipe to the exhaust and seal the joint with duct
tape. Make sure that it is completely airtight.
Duct Cover Installation
15. Attach the two duct cover mounting bracket on the wall as seen
in Figure 4.
16. Place the inner duct cover and outer duct cover over the range
hood.
17. Secure the outer duct cover to the range hood body with the 5
x 12 mm screws provided.
18. Pull the inner duct cover up until it aligns properly to the duct
cover mounting bracket, then secure to the duct cover mounting
bracket with 5 x 12 mm screws. Refer to Figure 3 and 4.
Figure 1
Figure 2
*NOTE: Sample image only. May not be actual model.
Figure 3
Figure 4
*NOTE: Sample image only. May not be actual model.
*NOTE: Sample image only. May not be actual model.
Duct Cover
Mounting Bracket
Loading ...
Loading ...
Loading ...