Loading ...
Loading ...
Loading ...
First Steps
(continued)
Figure 1
Copper water line from
household water supply.
Figure 2
U
i
Brass nut _}
Ferrule 0
0
0
0
0
0
Figure 3
Figure 4
Wire
Signal Arm
Ice Maker
Connecting Ice Maker to Water Supply
Do Not Install Ice Maker Tubing Where Temperature May
Fall Below Freezing.
Check to besure your water connection will comply with local plumbing codes.
Water quality determines your icequality. It is best to connect the ice maker to
water that isnot softened. Chemicals from a malfunctioning softener can
damage the ice maker. If the ice maker isconnected to soft water, ensure that
the softener ismaintained and working properly.
The ice maker requires a 1/4 inch (6.4 mm) copper water supply line (with
shutoff) from your household water system. Allow enough tubing behind your
refrigerator to permit moving out to clean floor.
Water line kit 5308950117 isavailable through your dealer at extra charge. This
kit includes 25 feet (7.6 meters) of 1/4 inch diameter copper tubing, plus parts to
connect to your cold water line, including a saddle valve assembly. You will need
to purchase a 1/4 inch brasscompression nut and ferrule from your local hard-
ware or plumbing store.
1. Turn ON water supply and flush out copper tubing. Turn off water supply.
2. Unplug refrigerator.
3. Install WATERSUPPLYLINEasfollows (figure 2):
• Slide brassnut, then ferrule, onto copper tubing.
Pushend of copper tubing asfar into the metal water valve fitting as it will
go (1/4 inch). Slide ferrule into fitting and thread brass nut onto inlet,
tighten finger tight plus 1/2 turn with wrench.
NOTE: Some models may have a cap on the valve. Unscrew the cap and
discard.
4. Secure copper tubing with STEELCLAMP and screw to rear panel at location
shown (Figure3).
5. Coil water supply tubing asshown (figure 3).
NOTE: To prevent vibration noise and wear, leave a space between all tubing
and other surfaces.
6. Turn on water supply and check all connections for leaks (figure 3).
7. Plug refrigerator cord into wall outlet.
8. Tobegin ice production, lower the Wire Signal Arm to the "down" or "ON"
position (Figure 4).
IMPORTANT
Ice production will begin when freezer reaches normal operating temperature.
Air in new plumbing lines may cause ice maker to cycle two or three times
before making a full tray of ice.
New plumbing may cause iceto be discolored or have poor flavor. Discard ice
made during the first 24 hours. After installation, if you wish to shut the ice
maker off, lift the Wire Signal Arm until it clicks and locks in the "UP" position.
Loading ...
Loading ...
Loading ...