Loading ...
Loading ...
Loading ...
WARNING
6.1 Control Panel and Function Keys
Timer Button
Light Button
Speed Button
Power Button
Best results are obtained by using a low speed for
normal conditions and a high speed when odors are
more concentrated.
Turn the hood on for a few minutes before you start
cooking.
The hood should be left on for 15 minutes after
cooking or until all odors have dispersed.
The control switches are located on the front panel of
the unit. See Image below.
When the rangehood is in operation and the TIMER
button is pressed, the rangehood switches to timer
mode. Press again to exit the timer function. The
above steps can be operated repeatedly.
The default setting is 9 minutes. The timer then starts
counting down the time. The remaining time is
shown in the display: 9 > 8 > 7 > 6 > 5 > 4 > 3
> 2 > 1 > 0. When [0] is shown, the rangehood is
automatically switched off.
Press and hold the TIMER button to deactivate the
timer again.
Press the LIGHT button to switch on the light. Press
the button again to switch it off.
The lamp function could be operated without
pressing the power button.
The motor offers 3 speed levels: low/1, medium/2
and high/3.
Press the INCREASE / REDUCE button several times
to run the motor at the following power: low >
medium > high > low. LED display shows the
corresponding speed: 1 > 2 > 3 >1.
Press the POWER button to switch the rangehood on
and off.
The rangehood may only be operated when the aluminum
stainless steel grease filter and of the rangehood is installed
(see “Installation Instructions” section).
Clean the cooking zone before using the cooktop for the
first time (see the “Cleaning” section).
Observe all safety and warning information during
operation (see the “General Safety Instructions” section).
6. OPERATION
7
www.linarie.com.au
1
2
3
4
4 2 3 1
Display
6.2 Energy Saving tips
This rangehood operates very efficiently and economically.
The following will help you to save even more energy when
using it:
Ensure that there is sufficient ventilation in the kitchen
when cooking. In extraction mode, if there is
insufficient air flow the rangehood cannot operate
efficiently and this causes increased operating noise
levels.
Always cook with the lowest possible setting. This
produces fewer cooking vapors, so you can use a
lower rangehood power level and therefore benefit
from reduced energy consumption.
Check the power level selected on the rangehood. A
lower power level is generally sufficient for the majority
of cooking. Only use the Booster setting when
necessary.
When a large volume of cooking vapors is being
produced, switch to a high-power level in good time.
This is more efficient than operating the rangehood
for longer to try to capture cooking vapors which have
already been distributed throughout the kitchen.
Make sure that you switch the rangehood off after use.
Clean or change the filters at regular intervals. Heavily
soiled filters reduce performance, increase the risk of
fire and are unhygienic.
Loading ...
Loading ...
Loading ...