Blue Seal Evolution G512C-B Installation Operation Manual

Loading ...

- All Other Markets

NOTE:

 (*) Measure Burner operating pressure at manifold test point with two burners operating at

'High Flame' setting.

 NAT, LPG & Butane Only - Operating pressure is ex-factory set and is not to be adjusted,

unless when converting between gases, if required.

 (**) TOWN GAS Only - Adjust burner operating pressure using adjustable gas regulator

supplied.

 Refer to ‘Gas Conversion and Specifications' section in this manual for further details.

Gas supply connection point is located at rear of appliance, approximately 130mm from right hand

side, 32mm from rear and 655mm from floor (55mm for bench top – B models) and is reached from

beneath appliance. (Refer to ‘Dimensions’ section). With exception of G512C and G512D

models which are 100mm from right hand side, 32mm from rear and 70mm from floor.

Connection is ½" BSP male thread (for G512C and G512D models).

Connection is ¾" BSP male thread (for all other models).

Input Rate (N.H.G.C.)

- each Open Burner

28 MJ/hr

- each 300mm Griddle Section

21 MJ/hr 21 MJ/hr

Supply Pressure

2.75 - 4.50 kPa 2.75 - 4.50 kPa

Burner Operating Pressure (*)

2.6 kPa 2.6 kPa

Gas Connection

See ‘Gas Connection’ information overleaf.