Loading ...
Loading ...
Loading ...
www.SereneLifeHome.com
6
How much air is the right amount?
In general, the banana boat is full when it is very rm. An adult should be able to sit on the tube and only
sink a couple of inches. Banana boats need to be full of air and properly maintained for long product life.
BANANA BOAT REPAIRS
Before you begin, make sure you are working in a well-ventilated area, climate controlled to at least 70
degrees. It is advised that you wear protective gloves when working with chemicals.
After you have done the repair to the tube, it must sit undisturbed for at least 24 hours.
When making a repair, do not inate tube to maximum capacity. It is recommended that the tube be
semi-soft for all repairs.
Repairing Holes in the Tube:
1. Cut the patch larger than the area to be repaired. Be sure to round the corners of the patch.
Use the patches enclosed with your banana boat.
2. Place the patch over the area to be repaired, outline with a pen.
3. Wipe patch with clean towel. Using a clean towel, wipe area on the tube to be repaired.
4. Place one thin coat of glue on the patch and one thin coat of glue on the tube.
WAIT 5 minutes.
5. Place patch on glued area
6. With dull instrument, starting at the center of the patch, gently smooth the patch in place, paying attention
to all corners and sides of the patch.
7. Use repair adhesive to outline patch to assure patch is sealed.
8. Remove any glue residue. Allow boat to sit for 24 hours. Don’t rush the drying.
9. Air up the tube and check for leaks.
Repairing Leaks in Seam Area:
If a seam is leaking, it is strongly suggested that you send your tube to a professional inatable boat repair
company for repairs. You can look online by using Google searching “inatable boat repair” in your city or
state to nd a boat repair company.
TIP: If you try to repair a small break in the seam, use the repair instructions above.
BANANA BOAT STORAGE
Storing the banana boat after use:
1. Wipe down banana boat. If banana boat is dirty, clean with mild soap and water rst then dry completely.
DO NOT USE ARMORAL OR PRODUCTS CONTAINING PETROLEUM DISTILLATES.
2. Be sure the boat is dry before storing.
3. Fold pontoons in toward seated area on banana boat. Then fold banana boat in small squares.
Place in a sealable plastic bin.
4. Store in a dry covered cool area. Note- storing in damp or humid areas area can cause glued areas to
separate. Avoid areas that have mice or rodents.
USER ASSUMES ALL RISKS AND LIABILITY FOR LOSS, DAMAGE, OR INJURY TO YOU OR YOUR PROPERTY,
AND TO OTHERS AND THEIR PROPERTY, ARISING OUT OF USE, MISUSE, OR INABILITY TO USE THE
WATER SLED BANANA BOAT.
Loading ...
Loading ...