Loading ...
Loading ...
Loading ...
• Changetheoilafterevery25hoursof
operationoreachseason. Youmay
needto changetheoil moreoften
underdusty,dirtyconditions. See"TO
CHANGEENGINEOIL"intheMainte-
nancesectionof thismanual.
Engine
oil cap
ATTACH FUEL CAP CARTRIDGE
Your mower is equipped with a special
FRESH START TMfuel cap and continuous
fuel preserver cartridge. See the infor-
mation and instructions packed with the
FRESH START TMcartridge.
1. Snap cartridge into bottom of fuel cap.
NOTE: Do not remove the silver foil seal
on the side of cartridge that snaps into fuel
cap.
2. Grasp the white peel tab and pull to
remove the entire seal.
3. Screw fuel cap onto fuel tank after fill-
ing tank with gasoline.
Replace cartridge when empty (about
once a season). Check preserver level
visually.
,_ DANGER: Cartridge fluid is HARMFUL
OR FATAL IF SWALLOWED. Avoid con-
tact to eyes, skin, or clothing. Do not take
internally. Do not inhale fluid vapor. Keep
out of reach of children. If swallowed, call
a physician immediately.
ADD GASOLINE
• Fill fuel tank to bottom of tank filler neck.
Do not overfill. Use fresh, clean, regular
unleaded gasoline with a minimum of
87 octane. Do not mix oil with gasoline.
Purchase fuel in quantities that can be
used within 30 days to assure fuel fresh-
ness.
A CAUTION: Wipe off any spilled oil or
fuel. Do not store, spill or use gasoline
near an open flame.
,_ CAUTION: Alcohol blended fuels
(called gasohol or using ethanol or metha-
nol) can attract moisture which leads to
separation and formation of acids during
storage. Acidic gas can damage the fuel
system of an engine while in storage. To
avoid engine problems, the fuel system
should be emptied before storage of 30
days or longer. Empty the gas tank, start
the engine and let it run until the fuel lines
and carburetor are empty. Use fresh fuel
next season. See Storage Instructions for
additional information. Never use engine
or carburetor cleaner products in the fuel
tank or permanent damage may occur.
Gasoline
filler cap
TO STOP ENGINE
• To stop engine, release operator pres-
ence control bar.
TO START ENGINE
NOTE: Due to protective coatings on the
engine, a small amount of smoke may be
present during the initial use of the product
and should be considered normal.
NOTE: Your engine is equipped with an
automatic choke system. No priming or
choking is required before starting.
• To start engine, hold operator presence
control bar down to the handle and pull
starter handle quickly. Do not allow
starter rope to snap back.
Loading ...
Loading ...
Loading ...