Loading ...
Loading ...
Loading ...
7 – English
This product contains no serviceable parts.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken or
destroy plastic which could result in serious personal
injury.
REMOVING THE ROLLER BRUSH FOR
CLEANING
See Figure 12, page 10.
The roller brush is located inside the roller bar assembly.
The roller bar assembly has a tool-free end cap, allowing
the roller brush to be easily removed for cleaning.
To remove:
Insert a coin into the slot on the end of the roller
brush as shown or use your hand. Rotate the end cap
approximately 1/4 in. counterclockwise to unlock the roller
brush.
Slide the brush to release the cap and pull the brush from
the roller bar assembly.
NOTE: Use scissors to remove any threads or hair
wrapped around the roller brush using the scissor
grooves.
MAINTENANCE
To reattach:
Insert the roller brush into the roller bar assembly.
Align the tabs on the cap to the notches on the roller bar
assembly and firmly press the cap into place.
NOTE: Make sure the opposite end of the roller brush is
aligned to the drive spindle when pressing the cap into
the assembly housing.
Turn the end cap 1/4 in. clockwise with coin to lock into
place.
CLEANING/REPLACING THE FILTER
See Figure 13, page 10.
Remove the battery pack and the dust bowl.
Push tab to open the door on the top of the dust bowl.
Remove the filter assembly by pulling it out of the dust
bowl.
Shake or lightly brush any dust or dirt off the filter
assembly.
Remove the filter by lifting away from the assembly. The
filter may be rinsed if necessary.
Empty the dust bowl; wash if necessary. Before reattach-
ing to the stick vac, make sure all pieces are completely
dry.
Reinsert the filter into the filter assembly.
Install the filter assembly into the dust bowl. Reattach
the dust bowl by aligning the slot on the bottom of dust
bowl with the tab on the bottom of motor housing, then
rotate and snap the two sections together.
NOTE: Allow 24 hours for parts to dry completely.
When purchasing a replacement filter assembly, request
recommended part number 903623004.
NOTE: ILLUSTRATIONS START ON PAGE 8 AFTER
FRENCH AND SPANISH LANGUAGE SECTIONS.
Loading ...
Loading ...
Loading ...