Loading ...
Loading ...
Loading ...
6
3. Desk Installation
3b. Hole Installation
Disassemble the desk clamp assembly by removing the clamp
adjustment screw, the two clamp adjustment plate screws and
the base plate’s three attachment screws.
Re-install the base plate with three retained attachment screws. Tighten securely.
From below the desk, insert retained clamp adjustment screw through pad and up through the hole in the desk.
Thread screw by turning the knob into base plate, but do not tighten completely at this time. Center the desk
mount assembly over the hole and then securely tighten the Clamp Adjustment Screw.
Note: min. hole diameter =10mm (.4”)
max. hole diameter =70mm (2.75”)
Base Plate
Pad
Attachment Screw
Clamp Adjustment Screw
Rubber Pad
4mm Hex Key
14-12-062-9333EA.indb 6 12/19/2014 10:03:07 AM
Loading ...
Loading ...
Loading ...