Hoshizaki KMD530MRJ Instruction Manual

Loading ...

G. Installation of Remote Condenser Unit for Remote Models

WARNING

• Installation of remote condenser unit must be performed by properly trained and

EPA-certied service personnel.

• The remote condenser unit must be installed in accordance with applicable

national, state, and local codes and regulations.

• Failure to install the remote condenser unit within these guidelines may adversely

affect safety, performance, component life, and warranty coverage.

• Power supply and ground wire to the remote condenser unit are supplied from the

icemaker. For details, see section "II.G.6. Electrical Connection."

1. Location

NOTICE

• The remote condenser unit is intended for outdoor use. Normal operating ambient

temperature must be within -20°F to +122°F (-29°C to +50°C). Operation of the

remote condenser unit, for extended periods, outside of this normal temperature

range may affect appliance performance.

• The maximum line length for the standard line sizes and refrigerant charge is

66' (20-m). With larger line sizes and/or additional refrigerant, the maximum line

length is 100' (30.5-m). For details, see "II.G.4 Line Set Size and Refrigerant

Charge."

• The maximum vertical distance between the remote condenser unit and the

icemaker is 33' (10-m) above or 10' (3-m) below the icemaker. These distances

are measured tting to tting. See Fig. 11.

The remote condenser unit must be positioned in a permanent site under the following

guidelines:

• A rm and at site.

• A dry and well ventilated area with 24" (61-cm) clearance at front and rear for proper air

circulation and ease of maintenance and/or service should they be required. See Fig. 12.

Fig. 11

Min. 24" (61 cm) Clearance

Air Air

Fig. 12

Icemaker

Remote

Condenser

Unit

Service Loop

Max.

33'

(10 m)