Loading ...
Loading ...
Loading ...
• Assemble the adapter bracket to the deck using two
5/16" x 1• hex bolts, 5/16" flat washers and 5/16" hex
lock nuts. See figure 31.
NOTE: It may be necessary to use extra 5116" flat
washers to shim under the bracket next to the deck
surface. Ten extra washers have been furnished as
shims. See figure 31.
, (2) 5/16" HEX
L
,.j=.=1 LOCK NUTS
I
L
_' _--,---- (2) 5/16" FLAT
._ WASHERS
I i
ADAPTER BRACKET !_
' 5116" flat washers
,,,!_ used as needed for
5/16" x 1" HEX BOLT shims to adjust for
variations in decks.
11.
FIGURE 31
With deck adapter positioned correctly over the
discharge opening, use the adapter bracket as a
template and drill three 9132" diameter holes in the
top of the deck adapter. See figure 32.
Bolt deck adapter to bracket using three 1/4" x 3/4"
bolts, nylon washers, 114"flat washers and !/4" hex
lock nuts. Nylon washers should be against ti_e
inside of the deck adapter. See figure 32.
DECKADAPTER
_)I_"HEX
LOCK NUTS
ADAPTER
BRACKET
(3) NYLON MOWER DECK
WASHERS
(3) 1/4" STEEL WASHERS
(3)1_"x _4"HEXBOLTS
FOR 1990 AND NEWER MURRAY
TRACTORS WITH A 38" OR 40" DECK
Cut out two templates and place on deck adapter as
shown in figure 33. Tape smaller one on top and
larger one on the side and bottom. After they are in
place, carefully mark around the templates, then cut
out adapter to obtain correct opening.
Bolt end of mounting strap to the 5/16 • bolt on the
mower deck. The other end of the strap will bolt to a
hole in the deck adapter, which must be drilled.
Position the adapter on the deck, then drill a 5/16"
hole in the bottom of the adapter that will align with
the hole in the strap. Fasten the adapter to the strap
using one 1/4" x 3/4" hex bolt, 1/4" flat washer, nylon
washer and 1/4" hex lock nut. See figure 33.
38"140"TEMPLATE
TEMPLATE TO CUT OUT SLOT
CUT OUT SLOT IN TOP
OF BECK ADAPTER
1/4" x 3/4" HEX BOLT
1/4" FLAT WASHER
NYLON WASHER
BOLT THIS END OF
STRAP TO _glS" BOLT
ON MOWER DECK
1/4" HEX LOCK NUT
FIGURE 33
Assemble end of hose and hose clamp over the
round opening of deck adapter and tighten clamp.
GO DIRECTLY TO THE OPERATION INSTRUC-
TIONS WHICH ARE LOCATED ON PAGE 19.
FIGURE 32
9. Assemble end of hose and a hose clamp over the
round opening of deck adapter and tighten clamp.
GO DIRECTLY TO THE OPERATION INSTRUC-
TIONS ON PAGE 19.
17
Loading ...
Loading ...
Loading ...