Loading ...
Loading ...
Loading ...
INSTALLING BITS
I Place the direction of rotation selector in center position.
See Figure 3. This will turn oft the power to your drill.
• Open or close the chuck jaws to a point where the
opening is stlghtly larger than the bit size you intan0 to
use. Also, raise the ('ront ot your drill slightly to kee_, the
bit froro falling out of the chuck jaws.
I {nser_ your dri(1 bit Into the chuck the full length of the
jaws. See Figure 7,
RELEASE
(UNLOCK)
CHUCK BODY
REMOVING BITS
See Figure 7.
• Ptace the direction of rotation selector in center
position. See Figure 3. This wi(l turn off the power to
your drill.
• Loosen the chuck jaws from drill bit.
/I To loosen: grasp and hold the collar of the chuck with
one hand, while rotating chuck body with your other
hand.
Note: Rotate chuck body in the direction of the arrow
marked RELEASE to loosen chuck jaws.
• DO NOT use a wranch to t_hten or _:;osen the chu_ck
]_ws.
• Remove drillbit from chuck iaws.
BIT
CHUCKCOLLAR
• Tighten the chuck jaws on the drill bit. To tighten, grasp
and hold the collar of the chuck with one hand, while
rotating the chuck body with your other hand.
Note: Rotate the chuck body in the direction of the arrow
marked GRIP to tighten the chuck jaws. DO Nor use a
wrench to tighten or loosen the chuck jaws.
,l_ WARN|NG; Do not insert drill bit into chuck jaws and
tighten as shown in Figure 8. This could cause drill bit
to be thrown from drill resulting in possible serious
personal injury or damage to the chuck.
Fig. 8
11
Loading ...
Loading ...
Loading ...