Loading ...
Loading ...
Loading ...
Settings
Protection Mode Error Codes
Hot
E10
E20
Overheating Protection: When the motor has been working
continuously for 2 minutes, it will stop operating to prevent
damage from overheating. Wait for at least 18 minutes
before making any further height adjustment.
Sensor Malfunction Warning: Motor safety sensor can't be
detected. Power o, check the connection between the motor
and controller, and power back on again.
Overloading Warning: Max load exceeded. If raising the desk
take the things o the desk and try again. If lowering the
desk, power o, take the things o the desk, power back on
and try again.
Change Display Height Units
Press and hold the button until a flashing'S--'is displayed. Press again
and'Un'is displayed. Press to select it, press or to switch between
'IN'(imperial) and'SI' (metric), and press to save your choice.
S
S
S
Change Collision Detection Sensitivity
Press and hold the button until a flashing'S--'is displayed. Press again
and'Un'is displayed. Press or to switch to'CF'and press to select it.
Press or to switch between o, low, normal, and high sensitivity.
Press to save your choice.
S
v
v
S S
S
S
v
v
v
v
Reset
Press and hold the button for 5 seconds, and the screen
will show 'RES'.Continue holding until the desk goes down to its lowest
level and comes back up slightly.
v
Loading ...
Loading ...