Loading ...
Loading ...
Loading ...
Section 2 - OPERATING INSTRUCTIONS
2.2.2. PROPELLING MOWER
(Self Propelled Models)
1. Move ground speed control to the desired
speed position. See Figure 2.4.
2. Move wheel drive control against handle to
engage wheel drive and propel mower forward.
Forward speed can be adjusted while the mower is
moving by changing position of the ground speed
control. See Figure 2.4.
MOVE CONTROL MOVE GROUND
AGAINST HANDLE BLADE
SPEED CONTROL
TO ENGAGE CONTROL
TO DESIRED
WHEEL DRIVE POSITION
WHEEL DRIVE
CONTROL
2.3
2.4
FIGURE 2.4
STOPPING
Stop engine and blade by releasing the blade
control. Stop forward motion of mower by releasing
the wheel drive control.
HANDLE HEIGHT ADJUSTMENT
The height of the mower handle can be adjusted
as follows:
1. Loosen the nuts on each lower handle as
shown in Figure 2.5.
HIGHER
LOWER
HANDLE
I
LOWER
LOOSEN LOWER
NUTS ON EACH
LOWER HANDLE
FIGURE 2.5
IMPORTANT! Some models are equipped with braces
that attach to the lower handle brackets and must be
loosened before handle height can be adjusted.
2. Move upper mower handle up or down until the
desired position is achieved.
3. Tighten the lower nuts on each lower handle to
maintain desired position.
WARNING
" and mower blade by releasing the I
eio_ng!io_ before adjusting cutting height orI
2.5 CUTTING HEIGHT ADJUSTMENT
1. Pull the height adjusting latch outward and
move to desired cutting height. See Figure 2.6.
LOWEST CUTTING
'''HEIGHT r---LATCH
/
FIGURE 2.6
2. Set all wheels at the same cutting height. The
highest cutting position is Notch 6. The lowest
cutting position is Notch 1. See Figure 2.7.
LATCH
POSITIONS
CUTTING HEIGHT SETTINGS
FIGURE 2.7
Loading ...
Loading ...
Loading ...