Loading ...
Loading ...
Loading ...
– 1
Please read and comply with these origi-
nal instructions prior to the initial opera-
tion of your appliance and store them for
later use or subsequent owners.
Please observe the safety in-
structions of your high-pres-
sure cleaner.
Only trigger the high-pres-
sure jet at the high-pressure
gun if the T-Racer is located
on the surface to be cleaned.
There must be no persons in
the immediate vicinity of the
cleaning head.
Beware of the recoil! Ensure
a stable position and firmly
hold the high-pressure gun
with the extension tube.
When working on the T-Rac-
er, disconnect it from the
high-pressure gun.
When unpacking the product, make sure that no acces-
sories are missing and that none of the package con-
tents have been damaged. If you detect any transport
damages please contact your dealer.
Illustration
1 Extension tube
2 Adapter
3Casing
4 Rotor arm
5 High pressure nozzle
The T-Racer is ideally suited for the cleaning of floor
and wall surfaces made of different materials such as
wood, plastic, concrete, tiles, and natural stone. Use the
T-Racer for private households only.
This device is intended for use with the K 2 / K 3 high-
pressure cleaner only.
DANGER
Do not reach under the edge of the T-Racer
during operation!
Install the adapter in the casing.
Illustration
1 Take the adapter into the opening of the casing.
2 Turn the adapter clockwise until it snaps into place.
Note
Onetime installation. The adapter cannot be unlocked
anymore.
Fasten the T-Racer to the high-pressure gun using the
extension pipe.
Illustration
Press the extension tube int
o the bayonet connec-
tion of the high-pressure gun, then turn by 90° until
it locks into place.
The
T-Racer
is not suited for scouring or scrubbing!
Outdoor surfaces should be swept before the T-
Racer is used to avoid damaging the high-pressure
nozzles.
Guide the T-Racer over the surface without effort.
Illustration
몇 CAUTION
Do not run over protruding corners!
High-pressure cleaner does not build up the pres-
sure or is vibrating.
Clean or replace high-pressure nozzle.
Illustration
1 Remove the clip.
2 Pull out the high-pressure nozzle.
3 Rinse the high-pressure nozzle with clean water,
replace if necessary.
4 Insert the nozzle.
5 Reinsert the clip.
You can use the extension pipe with any Kärcher acces-
sory.
Use a moist cloth and clean the appliance after use.
Store the appliance in a frost free area.
The packaging material can be recycled. Please
do not place the packaging into the ordinary re-
fuse for disposal, but arrange for the proper re-
cycling.
Old appliances contain valuable materials that
can be recycled. Please arrange for the proper
recycling of old appliances. Please dispose your
old appliances using appropriate collection sys-
tems.
Notes about the ingredients (REACH)
You will find current information about the ingredients
at:
www.kaercher.com/REACH
Safety instructions
Description of the Appliance
Proper use
Symbols on the machine
Application
Preparatory operations
Cleaning floor surfaces
Tips for cleaning
Troubleshooting
General information
Tip
Care
Environmental protection
4 EN
Loading ...
Loading ...
Loading ...