Loading ...
Loading ...
Loading ...
Setting Surface Controls
Operating the Dual Surface Radiant Element
The cooktop is equipped with a dual radiant surface
element located at the right front (See Figures 1 & 2)
positions. The unit control knob area has a dual set of
graduations, For small utensils turn the control knob as
shown on figure 3; for larger utensils turn the control knob .....
as shown on figure 4. Only the inner surface of the unit
heats when using it for small utensils; the whole surface
heats for large utensils. You may switch between settings at
any time during cooking,
To Operate the Dual Surface Element:
1. Place correctly sized cookware on the dual surface
element.
2. Push in and turn the control knob counterclockwise
(See Figure 3) for smaller cookware or clockwise (See
Figure 4) for larger cookware.
3. Turn the knob to adjust the setting if needed, Start most
cooking operations on a higher setting and then turn to
a lower setting to finish cooking, Each surface element
provides a constant amount of heat at each setting. A
glowing red surface heating area extending beyond the
bottom edge of the cookware indicates the cookware is
too small for the surface heating area,
4. When cooking has completed, turn the surface
control knob to OFF before removing the cookware.
Note: The Surface Indicator light will come on when the
control knob is turned on and will continue to glow until
the glass cooktop has cooled down to a moderate level,
The light may remain on even though the controls are
turned OFR
Note: See previous page for table of recommended
control settings,
Figure 1
8 6
@
Figure 2
8 6
4
LO
o HI
8 6 4 8 6 4
Figure 3 Figure 4
Single Setting Dual Setting
LO
2
Dual Radiant heating areas on ceramic smooth top
(shown in black)
r
Loading ...
Loading ...
Loading ...