Loading ...
Loading ...
Loading ...
GB
- 14 -
3. Push the battery pack onto the battery char-
ger.
In section 8 (Charger indicator) you will fi nd a
table with an explanation of the LED indicator on
the charger.
If the battery pack fails to charge, check for the
following:
•
voltage at the power socket
•
whether there is good contact at the charging
contacts of the charging unit
If the battery pack still fails to charge, send
•
the charger
•
and the battery pack
to our customer service center.
To ensure that the battery pack provides long ser-
vice, you should take care to recharge it promptly.
You must recharge the battery pack when you
notice that the power of the cordless lamp drops.
Never allow the battery pack to become fully di-
scharged. This will cause it to develop a defect.
4.3 Switching on and off and adjusting the
brightness (Fig. 2/Item 3)
Switching on:
Turn the ON/Off switch (3) clockwise until you
hear a click.
The lamp will then come at the lowest level.
Adjusting the brightness:
The brightness of the lamp is continuously adjus-
table to individual requirements.
To increase the brightness of the lamp, turn the
On/Off switch (3) clockwise. To reduce the bright-
ness of the lamp, turn the On/Off switch (3) coun-
terclockwise.
Switching off :
Turn the ON/Off switch (3) counterclockwise until
you hear a click.
4.4 Adjusting the lighting position
•
You can adjust the lamphead to any lighting
position you want by turning it.
•
To do so, undo the fastening screws for the
lamphead (4) on both sides of the equipment.
•
Now adjust it to the lighting position you re-
quire and then retighten the fastening screws
for the lamphead (4).
4.5 Fastening the lamp with the hook (Fig.
5-6/Item 10)
•
The lamp can also be hung up easily using
the hook (10).
•
To do so, undo the fastening screws for the
foot (5) on both sides of the equipment.
•
Swivel the frame of the lamp as far as the
stop (Fig. 5).
•
Then retighten the fastening screws for the
foot (5).
•
Hang up the lamp, e.g. from a cable (Fig. 6).
4.6 Battery charge level indicator (Fig. 7)
Press the button for the battery charge level indi-
cator (b). The battery charge level indicator (c) will
indicate the charge status of the battery by means
of 3 LEDs.
All 3 LEDs are lit:
The battery is fully charged.
2 or 1 LED(s) are lit:
The battery has an adequate remaining charge.
1 LED blinks:
The battery is empty, recharge the battery.
All LEDs fl ash:
The battery temperature is too high. Remove the
battery from the equipment, keep it at room tem-
perature for one day. If the fault reoccurs, this me-
ans that the rechargeable battery has undergone
exhaustive discharge and is defective. Remove
the battery from the equipment. Never use or
charge a defective battery.
5. Cleaning, maintenance and
ordering of spare parts
Danger!
Always pull out the battery pack before starting
any cleaning work.
5.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
Anl_TC_CL_18_1800_Li_SPK9.indb 14Anl_TC_CL_18_1800_Li_SPK9.indb 14 10.07.2019 10:22:5910.07.2019 10:22:59
Loading ...
Loading ...
Loading ...