Loading ...
Loading ...
Loading ...
8 — English
OPERATION
WARNING:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict severe injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes, resulting in possible
serious injury.
APPLICATIONS
You may use this tool for the purposes listed below:
Finish and Trim (Interior and exterior)
Door & Window Casing
Door Jambs
Baseboard
Crown Molding
Cabinetry
Cap and Shoe Molding
Molding
Staircases
Door and Window Trim
Chair Rail
Brickmold
Hardwood Flooring
Paneling
Furniture
ATTACH BELT CLIP
See Figure 1, page 12.
The belt clip can be installed on the left or right side of the
nailer, depending on operator preference.
Alignbeltclipandscrewwithrightorleftsidescrewhole.
Usingaphillipsheadscrewdriver(notincluded)tighten
securely.
TO INSTALL / REMOVE BATTERY PACK
See Figure 2, page 12.
To install battery pack:
Place battery pack in the tool. Align raised rib inside tool
with groove on battery pack.
Make sure the latches on each side of the battery pack
snap into place and battery pack is secured in tool before
beginning operation.
NOTE: Squeeze LED light grip switch to reactivate nailer.
To remove battery pack:
Locate latches on battery pack and depress to release
battery pack from the tool.
NO-MAR PAD
See Figure 3, page 12.
The no-mar pad attached to the nose of the tool helps pre-
vent marring and denting when working with softer woods.
Remove the battery. Remove the pad by pulling it down and
away from the nose. To replace the pad, fit it into place over
the nose and push up to reseat.
On-board storage for the pad is located on the magazine of
the tool. An extra no-mar pad is provided in the on-board
storage area.
LOADING THE TOOL WITH BRAD NAILS
See Figures 4 - 5, page 12.
WARNING:
Keep the tool pointed away from yourself and others
when loading nails. Failure to do so could result in pos-
sible serious personal injury.
Remove battery pack from the tool, if installed.
With the nose of the tool pointed away from you, squeeze
magazine release button located at the rear of the maga-
zine and slide the magazine cover open.
Place brad nails in the channel with nail tips pointing down
and resting on bottom of the channel.
Push the magazine cover closed until it securely snaps
into place.
Make sure that the magazine is securely locked in place.
Reinstall battery, and reactivate nailer by pressing the
worklight grip switch.
Loading ...
Loading ...
Loading ...