Loading ...
Loading ...
Loading ...
5
INSTALLATION INSTRUCTIONS
Before Using Your Appliance
• Remove the exterior and interior packing materials.
• Before connecting the refrigerator to the power source, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from being handled
during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
Installing Your Appliance
This appliance is designed to be free-standing only, and should not be recessed or built-in.
Place the appliance on a floor or other surface that is strong enough to support it when fully
loaded. To level your appliance, adjust the leveling leg at the bottom.
Allow about 5” (12 cm) of space at the back and sides of the appliance and 4” (10 cm) at the top.
This will allow the proper air circulation to cool the compressor.
Locate the appliance away from direct sunlight and sources of heat (oven, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extremely cold ambient temperatures may also cause the refrigerator not to
perform properly.
Avoid locating the appliance in moist areas.
Plug the appliance into an exclusive, properly installed, grounded wall outlet. Do not under any
circumstances cut or remove the third (grounding) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized service center.
After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3 hours before
placing items inside the cabinet.
Electrical Connection
This appliance should be properly grounded for your safety. The power cord is equipped with a
three-pin plug which mates with standard three-prong wall outlets to minimize the possibility of
electrical shock.
Do not under any circumstances cut or remove the third ground prong from the power cord supplied.
This refrigerator requires a standard 115Volts AC~ 60Hz electrical outlet with a three-prong
grounded receptacle.
To prevent accidental injury, the cord should be secured behind the appliance and not left exposed
or dangling.
Never unplug the refrigerator by pulling the power cord. Always grip the plug firmly and pull it straight
out from the receptacle.
Do not use an extension cord with this appliance. If the power cord is too short, have a qualified
electrician or service technician install an outlet near the appliance.
Loading ...
Loading ...
Loading ...